Message ID | 1309970263-13239-3-git-send-email-shawn.guo@linaro.org (mailing list archive) |
---|---|
State | New, archived |
Headers | show |
On Thu, Jul 07, 2011 at 12:37:42AM +0800, Shawn Guo wrote: > The patch removes MXC_GPIO_IRQS and instead uses ARCH_NR_GPIOS to > define gpio number. This change is need when we change mxc gpio > driver to be device tree aware. When migrating the driver to device > tree, pdev->id becomes unusable. It requires driver get gpio range > from gpio core, which will dynamically allocates number from > ARCH_NR_GPIOS to 0. > > As a bonus point, it removes lines of '#if' and make the code a > little bit cleaner. The side effect is the waste of number. But > this is not a point when we go single image. I'm not sure whether we really should depend on an externally defined ARCH_NR_GPIOS. Someone might get the idea to change this to a lower value. Maybe we should define this ourselves instead. Any other opinions? Otherwise I'm fine with this patch. Sascha > > Signed-off-by: Shawn Guo <shawn.guo@linaro.org> > Cc: Sascha Hauer <s.hauer@pengutronix.de> > Cc: Grant Likely <grant.likely@secretlab.ca> > --- > arch/arm/plat-mxc/include/mach/irqs.h | 21 +++------------------ > 1 files changed, 3 insertions(+), 18 deletions(-) > > diff --git a/arch/arm/plat-mxc/include/mach/irqs.h b/arch/arm/plat-mxc/include/mach/irqs.h > index 35c89bc..00e812b 100644 > --- a/arch/arm/plat-mxc/include/mach/irqs.h > +++ b/arch/arm/plat-mxc/include/mach/irqs.h > @@ -11,6 +11,8 @@ > #ifndef __ASM_ARCH_MXC_IRQS_H__ > #define __ASM_ARCH_MXC_IRQS_H__ > > +#include <asm-generic/gpio.h> > + > /* > * SoCs with TZIC interrupt controller have 128 IRQs, those with AVIC have 64 > */ > @@ -22,30 +24,13 @@ > > #define MXC_GPIO_IRQ_START MXC_INTERNAL_IRQS > > -/* these are ordered by size to support multi-SoC kernels */ > -#if defined CONFIG_SOC_IMX53 > -#define MXC_GPIO_IRQS (32 * 7) > -#elif defined CONFIG_ARCH_MX2 > -#define MXC_GPIO_IRQS (32 * 6) > -#elif defined CONFIG_SOC_IMX50 > -#define MXC_GPIO_IRQS (32 * 6) > -#elif defined CONFIG_ARCH_MX1 > -#define MXC_GPIO_IRQS (32 * 4) > -#elif defined CONFIG_ARCH_MX25 > -#define MXC_GPIO_IRQS (32 * 4) > -#elif defined CONFIG_SOC_IMX51 > -#define MXC_GPIO_IRQS (32 * 4) > -#elif defined CONFIG_ARCH_MX3 > -#define MXC_GPIO_IRQS (32 * 3) > -#endif > - > /* > * The next 16 interrupts are for board specific purposes. Since > * the kernel can only run on one machine at a time, we can re-use > * these. If you need more, increase MXC_BOARD_IRQS, but keep it > * within sensible limits. > */ > -#define MXC_BOARD_IRQ_START (MXC_INTERNAL_IRQS + MXC_GPIO_IRQS) > +#define MXC_BOARD_IRQ_START (MXC_INTERNAL_IRQS + ARCH_NR_GPIOS) > > #ifdef CONFIG_MACH_MX31ADS_WM1133_EV1 > #define MXC_BOARD_IRQS 80 > -- > 1.7.4.1 > > >
On Thu, Jul 07, 2011 at 09:47:55AM +0200, Sascha Hauer wrote: > On Thu, Jul 07, 2011 at 12:37:42AM +0800, Shawn Guo wrote: > > The patch removes MXC_GPIO_IRQS and instead uses ARCH_NR_GPIOS to > > define gpio number. This change is need when we change mxc gpio > > driver to be device tree aware. When migrating the driver to device > > tree, pdev->id becomes unusable. It requires driver get gpio range > > from gpio core, which will dynamically allocates number from > > ARCH_NR_GPIOS to 0. > > > > As a bonus point, it removes lines of '#if' and make the code a > > little bit cleaner. The side effect is the waste of number. But > > this is not a point when we go single image. > > I'm not sure whether we really should depend on an externally defined > ARCH_NR_GPIOS. Someone might get the idea to change this to a lower > value. Maybe we should define this ourselves instead. > > Any other opinions? > > Otherwise I'm fine with this patch. /me would like to be rid of ARCH_NR_GPIOS entirely, but we're a long way away from that. g. > > Sascha > > > > > Signed-off-by: Shawn Guo <shawn.guo@linaro.org> > > Cc: Sascha Hauer <s.hauer@pengutronix.de> > > Cc: Grant Likely <grant.likely@secretlab.ca> > > --- > > arch/arm/plat-mxc/include/mach/irqs.h | 21 +++------------------ > > 1 files changed, 3 insertions(+), 18 deletions(-) > > > > diff --git a/arch/arm/plat-mxc/include/mach/irqs.h b/arch/arm/plat-mxc/include/mach/irqs.h > > index 35c89bc..00e812b 100644 > > --- a/arch/arm/plat-mxc/include/mach/irqs.h > > +++ b/arch/arm/plat-mxc/include/mach/irqs.h > > @@ -11,6 +11,8 @@ > > #ifndef __ASM_ARCH_MXC_IRQS_H__ > > #define __ASM_ARCH_MXC_IRQS_H__ > > > > +#include <asm-generic/gpio.h> > > + > > /* > > * SoCs with TZIC interrupt controller have 128 IRQs, those with AVIC have 64 > > */ > > @@ -22,30 +24,13 @@ > > > > #define MXC_GPIO_IRQ_START MXC_INTERNAL_IRQS > > > > -/* these are ordered by size to support multi-SoC kernels */ > > -#if defined CONFIG_SOC_IMX53 > > -#define MXC_GPIO_IRQS (32 * 7) > > -#elif defined CONFIG_ARCH_MX2 > > -#define MXC_GPIO_IRQS (32 * 6) > > -#elif defined CONFIG_SOC_IMX50 > > -#define MXC_GPIO_IRQS (32 * 6) > > -#elif defined CONFIG_ARCH_MX1 > > -#define MXC_GPIO_IRQS (32 * 4) > > -#elif defined CONFIG_ARCH_MX25 > > -#define MXC_GPIO_IRQS (32 * 4) > > -#elif defined CONFIG_SOC_IMX51 > > -#define MXC_GPIO_IRQS (32 * 4) > > -#elif defined CONFIG_ARCH_MX3 > > -#define MXC_GPIO_IRQS (32 * 3) > > -#endif > > - > > /* > > * The next 16 interrupts are for board specific purposes. Since > > * the kernel can only run on one machine at a time, we can re-use > > * these. If you need more, increase MXC_BOARD_IRQS, but keep it > > * within sensible limits. > > */ > > -#define MXC_BOARD_IRQ_START (MXC_INTERNAL_IRQS + MXC_GPIO_IRQS) > > +#define MXC_BOARD_IRQ_START (MXC_INTERNAL_IRQS + ARCH_NR_GPIOS) > > > > #ifdef CONFIG_MACH_MX31ADS_WM1133_EV1 > > #define MXC_BOARD_IRQS 80 > > -- > > 1.7.4.1 > > > > > > > > -- > Pengutronix e.K. | | > Industrial Linux Solutions | http://www.pengutronix.de/ | > Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | > Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | > > _______________________________________________ > linux-arm-kernel mailing list > linux-arm-kernel@lists.infradead.org > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
diff --git a/arch/arm/plat-mxc/include/mach/irqs.h b/arch/arm/plat-mxc/include/mach/irqs.h index 35c89bc..00e812b 100644 --- a/arch/arm/plat-mxc/include/mach/irqs.h +++ b/arch/arm/plat-mxc/include/mach/irqs.h @@ -11,6 +11,8 @@ #ifndef __ASM_ARCH_MXC_IRQS_H__ #define __ASM_ARCH_MXC_IRQS_H__ +#include <asm-generic/gpio.h> + /* * SoCs with TZIC interrupt controller have 128 IRQs, those with AVIC have 64 */ @@ -22,30 +24,13 @@ #define MXC_GPIO_IRQ_START MXC_INTERNAL_IRQS -/* these are ordered by size to support multi-SoC kernels */ -#if defined CONFIG_SOC_IMX53 -#define MXC_GPIO_IRQS (32 * 7) -#elif defined CONFIG_ARCH_MX2 -#define MXC_GPIO_IRQS (32 * 6) -#elif defined CONFIG_SOC_IMX50 -#define MXC_GPIO_IRQS (32 * 6) -#elif defined CONFIG_ARCH_MX1 -#define MXC_GPIO_IRQS (32 * 4) -#elif defined CONFIG_ARCH_MX25 -#define MXC_GPIO_IRQS (32 * 4) -#elif defined CONFIG_SOC_IMX51 -#define MXC_GPIO_IRQS (32 * 4) -#elif defined CONFIG_ARCH_MX3 -#define MXC_GPIO_IRQS (32 * 3) -#endif - /* * The next 16 interrupts are for board specific purposes. Since * the kernel can only run on one machine at a time, we can re-use * these. If you need more, increase MXC_BOARD_IRQS, but keep it * within sensible limits. */ -#define MXC_BOARD_IRQ_START (MXC_INTERNAL_IRQS + MXC_GPIO_IRQS) +#define MXC_BOARD_IRQ_START (MXC_INTERNAL_IRQS + ARCH_NR_GPIOS) #ifdef CONFIG_MACH_MX31ADS_WM1133_EV1 #define MXC_BOARD_IRQS 80
The patch removes MXC_GPIO_IRQS and instead uses ARCH_NR_GPIOS to define gpio number. This change is need when we change mxc gpio driver to be device tree aware. When migrating the driver to device tree, pdev->id becomes unusable. It requires driver get gpio range from gpio core, which will dynamically allocates number from ARCH_NR_GPIOS to 0. As a bonus point, it removes lines of '#if' and make the code a little bit cleaner. The side effect is the waste of number. But this is not a point when we go single image. Signed-off-by: Shawn Guo <shawn.guo@linaro.org> Cc: Sascha Hauer <s.hauer@pengutronix.de> Cc: Grant Likely <grant.likely@secretlab.ca> --- arch/arm/plat-mxc/include/mach/irqs.h | 21 +++------------------ 1 files changed, 3 insertions(+), 18 deletions(-)