@@ -53,6 +53,8 @@ static void __init csb337_init_early(void)
static struct macb_platform_data __initdata csb337_eth_data = {
.phy_irq_pin = AT91_PIN_PC2,
.is_rmii = 0,
+ /* The CSB337 bootloader stores the MAC the wrong-way around */
+ .rev_eth_addr = 1,
};
static struct at91_usbh_data __initdata csb337_usbh_data = {
@@ -21,7 +21,6 @@ if NET_CADENCE
config ARM_AT91_ETHER
tristate "AT91RM9200 Ethernet support"
- depends on ARM && ARCH_AT91RM9200
select NET_CORE
select MACB
---help---
@@ -32,8 +32,6 @@
#include <linux/phy.h>
#include <linux/io.h>
-#include <asm/mach-types.h>
-
#include "macb.h"
#define DRV_NAME "at91_ether"
@@ -61,9 +59,10 @@
static short __init unpack_mac_address(struct net_device *dev, unsigned int hi, unsigned int lo)
{
+ struct macb *lp = netdev_priv(dev);
char addr[6];
- if (machine_is_csb337()) {
+ if (lp->board_data.rev_eth_addr) {
addr[5] = (lo & 0xff); /* The CSB337 bootloader stores the MAC the wrong-way around */
addr[4] = (lo & 0xff00) >> 8;
addr[3] = (lo & 0xff0000) >> 16;
@@ -12,6 +12,7 @@ struct macb_platform_data {
u32 phy_mask;
int phy_irq_pin; /* PHY IRQ */
u8 is_rmii; /* using RMII interface? */
+ u8 rev_eth_addr; /* reverse Ethernet address byte order */
};
#endif /* __MACB_PDATA_H__ */
This will allow us to remove the last mach include from at91_ether and also make it easier to share address setup with macb. Signed-off-by: Joachim Eastwood <manabian@gmail.com> --- arch/arm/mach-at91/board-csb337.c | 2 ++ drivers/net/ethernet/cadence/Kconfig | 1 - drivers/net/ethernet/cadence/at91_ether.c | 5 ++--- include/linux/platform_data/macb.h | 1 + 4 files changed, 5 insertions(+), 4 deletions(-)