@@ -4,26 +4,26 @@ Marvell MVEBU SoCs usually allow to determine core clock frequencies by
reading the Sample-At-Reset (SAR) register. The core clock consumer should
specify the desired clock by having the clock ID in its "clocks" phandle cell.
-The following is a list of provided IDs and clock names on Kirkwood and Dove:
- 0 = tclk (Internal Bus clock)
- 1 = cpuclk (CPU0 clock)
- 2 = l2clk (L2 Cache clock derived from CPU0 clock)
- 3 = ddrclk (DDR controller clock derived from CPU0 clock)
-
-The following is a list of provided IDs and clock names on 370/XP:
+The following is a list of provided IDs and clock names on Armada 370/XP:
0 = tclk (Internal Bus clock)
1 = cpuclk (CPU clock)
2 = nbclk (L2 Cache clock)
3 = hclk (DRAM control clock)
4 = dramclk (DDR clock)
+The following is a list of provided IDs and clock names on Kirkwood and Dove:
+ 0 = tclk (Internal Bus clock)
+ 1 = cpuclk (CPU0 clock)
+ 2 = l2clk (L2 Cache clock derived from CPU0 clock)
+ 3 = ddrclk (DDR controller clock derived from CPU0 clock)
+
Required properties:
- compatible : shall be one of the following:
+ "marvell,armada-370-core-clocks" - For Armada 370 SoC core clocks
+ "marvell,armada-xp-core-clocks" - For Armada XP SoC core clocks
"marvell,dove-core-clocks" - for Dove SoC core clocks
"marvell,kirkwood-core-clocks" - for Kirkwood SoC (except mv88f6180)
"marvell,mv88f6180-core-clocks" - for Kirkwood MV88f6180 SoC
- "marvell,370-core-clocks" - For 370 SoC core clocks
- "marvell,xp-core-clocks" - For XP SoC core clocks
- reg : shall be the register address of the Sample-At-Reset (SAR) register
- #clock-cells : from common clock binding; shall be set to 1
new file mode 100644
@@ -0,0 +1,21 @@
+Device Tree Clock bindings for cpu clock of Marvell EBU platforms
+
+Required properties:
+- compatible : shall be one of the following:
+ "marvell,armada-xp-cpu-clockctrl" - cpu clocks for Armada XP
+- reg : Address and length of the clock complex register set
+- #clock-cells : should be set to 1.
+- clocks : shall be the input parent clock phandle for the clock.
+
+cpuclk: clock-complex@d0018700 {
+ #clock-cells = <1>;
+ compatible = "marvell,armada-xp-cpu-clockctrl";
+ reg = <0xd0018700 0xA0>;
+ clocks = <&coreclk 1>;
+}
+
+cpu@0 {
+ compatible = "marvell,sheeva-v7";
+ reg = <0>;
+ clocks = <&cpuclk 0>;
+};
@@ -1,3 +1,6 @@
config MVEBU_CLK_CORE
bool
+config MVEBU_CLK_CPU
+ bool
+
@@ -1 +1,2 @@
obj-$(CONFIG_MVEBU_CLK_CORE) += clk.o clk-core.o
+obj-$(CONFIG_MVEBU_CLK_CPU) += clk-cpu.o
@@ -634,11 +634,11 @@ static const struct core_clocks mv88f6180_core_clocks = {
static const __initdata struct of_device_id clk_core_match[] = {
#ifdef CONFIG_MACH_ARMADA_370_XP
{
- .compatible = "marvell,370-core-clocks",
+ .compatible = "marvell,armada-370-core-clocks",
.data = &a370_core_clocks,
},
{
- .compatible = "marvell,xp-core-clocks",
+ .compatible = "marvell,armada-xp-core-clocks",
.data = &xp_core_clocks,
},
#endif
new file mode 100644
@@ -0,0 +1,155 @@
+/*
+ * Marvell MVEBU CPU clock handling.
+ *
+ * Copyright (C) 2012 Marvell
+ *
+ * Gregory CLEMENT <gregory.clement@free-electrons.com>
+ *
+ * This file is licensed under the terms of the GNU General Public
+ * License version 2. This program is licensed "as is" without any
+ * warranty of any kind, whether express or implied.
+ */
+#include <linux/kernel.h>
+#include <linux/clkdev.h>
+#include <linux/clk-provider.h>
+#include <linux/of_address.h>
+#include <linux/io.h>
+#include <linux/of.h>
+#include <linux/delay.h>
+#include "clk-cpu.h"
+
+#define SYS_CTRL_CLK_DIVIDER_CTRL_OFFSET 0x0
+#define SYS_CTRL_CLK_DIVIDER_VALUE_OFFSET 0xC
+#define SYS_CTRL_CLK_DIVIDER_MASK 0x3F
+
+#define MAX_CPU 4
+struct cpu_clk {
+ struct clk_hw hw;
+ int cpu;
+ const char *clk_name;
+ const char *parent_name;
+ void __iomem *reg_base;
+};
+
+static struct clk **clks;
+
+static struct clk_onecell_data clk_data;
+
+#define to_cpu_clk(p) container_of(p, struct cpu_clk, hw)
+
+static unsigned long clk_cpu_recalc_rate(struct clk_hw *hwclk,
+ unsigned long parent_rate)
+{
+ struct cpu_clk *cpuclk = to_cpu_clk(hwclk);
+ u32 reg, div;
+
+ reg = readl(cpuclk->reg_base + SYS_CTRL_CLK_DIVIDER_VALUE_OFFSET);
+ div = (reg >> (cpuclk->cpu * 8)) & SYS_CTRL_CLK_DIVIDER_MASK;
+ return parent_rate / div;
+}
+
+static long clk_cpu_round_rate(struct clk_hw *hwclk, unsigned long rate,
+ unsigned long *parent_rate)
+{
+ /* Valid ratio are 1:1, 1:2 and 1:3 */
+ u32 div;
+
+ div = *parent_rate / rate;
+ if (div == 0)
+ div = 1;
+ else if (div > 3)
+ div = 3;
+
+ return *parent_rate / div;
+}
+
+static int clk_cpu_set_rate(struct clk_hw *hwclk, unsigned long rate,
+ unsigned long parent_rate)
+{
+ struct cpu_clk *cpuclk = to_cpu_clk(hwclk);
+ u32 reg, div;
+ u32 reload_mask;
+
+ div = parent_rate / rate;
+ reg = (readl(cpuclk->reg_base + SYS_CTRL_CLK_DIVIDER_VALUE_OFFSET)
+ & (~(SYS_CTRL_CLK_DIVIDER_MASK << (cpuclk->cpu * 8))))
+ | (div << (cpuclk->cpu * 8));
+ writel(reg, cpuclk->reg_base + SYS_CTRL_CLK_DIVIDER_VALUE_OFFSET);
+ /* Set clock divider reload smooth bit mask */
+ reload_mask = 1 << (20 + cpuclk->cpu);
+
+ reg = readl(cpuclk->reg_base + SYS_CTRL_CLK_DIVIDER_CTRL_OFFSET)
+ | reload_mask;
+ writel(reg, cpuclk->reg_base + SYS_CTRL_CLK_DIVIDER_CTRL_OFFSET);
+
+ /* Now trigger the clock update */
+ reg = readl(cpuclk->reg_base + SYS_CTRL_CLK_DIVIDER_CTRL_OFFSET)
+ | 1 << 24;
+ writel(reg, cpuclk->reg_base + SYS_CTRL_CLK_DIVIDER_CTRL_OFFSET);
+
+ /* Wait for clocks to settle down then clear reload request */
+ udelay(1000);
+ reg &= ~(reload_mask | 1 << 24);
+ writel(reg, cpuclk->reg_base + SYS_CTRL_CLK_DIVIDER_CTRL_OFFSET);
+ udelay(1000);
+
+ return 0;
+}
+
+static const struct clk_ops cpu_ops = {
+ .recalc_rate = clk_cpu_recalc_rate,
+ .round_rate = clk_cpu_round_rate,
+ .set_rate = clk_cpu_set_rate,
+};
+
+void __init of_cpu_clk_setup(struct device_node *node)
+{
+ struct cpu_clk *cpuclk;
+ void __iomem *clock_complex_base = of_iomap(node, 0);
+ int cpu;
+ if (clock_complex_base == NULL) {
+ pr_err("%s: clock-complex base register not set\n",
+ __func__);
+ return;
+ }
+
+ cpuclk = kzalloc(MAX_CPU * sizeof(*cpuclk), GFP_KERNEL);
+ clks = kzalloc(MAX_CPU * sizeof(*clks), GFP_KERNEL);
+
+ if (WARN_ON(!cpuclk))
+ return;
+ for (cpu = 0; cpu < MAX_CPU; cpu++) {
+ struct clk_init_data init;
+ struct clk *clk;
+ struct clk *parent_clk;
+ char *clk_name = kzalloc(5, GFP_KERNEL);
+
+ sprintf(clk_name, "cpu%d", cpu);
+ parent_clk = of_clk_get(node, 0);
+
+ cpuclk[cpu].parent_name = __clk_get_name(parent_clk);
+ cpuclk[cpu].clk_name = clk_name;
+ cpuclk[cpu].cpu = cpu;
+ cpuclk[cpu].reg_base = clock_complex_base;
+ cpuclk[cpu].hw.init = &init;
+
+ init.name = cpuclk[cpu].clk_name;
+ init.ops = &cpu_ops;
+ init.flags = 0;
+ init.parent_names = &cpuclk[cpu].parent_name;
+ init.num_parents = 1;
+
+ clk = clk_register(NULL, &cpuclk[cpu].hw);
+ if (WARN_ON(IS_ERR(clk)))
+ goto bail_out;
+ clks[cpu] = clk;
+ }
+ clk_data.clk_num = MAX_CPU;
+ clk_data.clks = clks;
+ of_clk_add_provider(node, of_clk_src_onecell_get, &clk_data);
+
+ return;
+bail_out:
+ kfree(clks);
+ kfree(cpuclk);
+}
new file mode 100644
@@ -0,0 +1,18 @@
+/*
+ * Marvell MVEBU CPU clock handling.
+ *
+ * Copyright (C) 2012 Marvell
+ *
+ * Gregory CLEMENT <gregory.clement@free-electrons.com>
+ *
+ * This file is licensed under the terms of the GNU General Public
+ * License version 2. This program is licensed "as is" without any
+ * warranty of any kind, whether express or implied.
+ */
+
+#ifndef __MVEBU_CLK_CPU_H
+#define __MVEBU_CLK_CPU_H
+
+void __init of_cpu_clk_setup(struct device_node *node);
+
+#endif
@@ -16,8 +16,22 @@
#include <linux/clk/mvebu.h>
#include <linux/of.h>
#include "clk-core.h"
+#include "clk-cpu.h"
+
+static const __initconst struct of_device_id clk_match[] = {
+#ifdef CONFIG_MVEBU_CLK_CPU
+ {
+ .compatible = "marvell,armada-xp-cpu-clockctrl",
+ .data = of_cpu_clk_setup,
+ },
+#endif
+ {
+ /* sentinel */
+ }
+};
void __init mvebu_clocks_init(void)
{
mvebu_core_clk_init();
+ of_clk_init(clk_match);
}