@@ -435,6 +435,7 @@ static int ci_hdrc_probe(struct platform_device *pdev)
struct resource *res;
void __iomem *base;
int ret;
+ int dr_mode;
if (!dev->platform_data) {
dev_err(dev, "platform data missing\n");
@@ -487,14 +488,22 @@ static int ci_hdrc_probe(struct platform_device *pdev)
return -ENODEV;
}
+ dr_mode = ci->platdata->dr_mode;
+ if (dr_mode == USB_DR_MODE_UNKNOWN)
+ dr_mode = USB_DR_MODE_OTG;
+
/* initialize role(s) before the interrupt is requested */
- ret = ci_hdrc_host_init(ci);
- if (ret)
- dev_info(dev, "doesn't support host\n");
+ if (dr_mode == USB_DR_MODE_OTG || dr_mode == USB_DR_MODE_HOST) {
+ ret = ci_hdrc_host_init(ci);
+ if (ret)
+ dev_info(dev, "doesn't support host\n");
+ }
- ret = ci_hdrc_gadget_init(ci);
- if (ret)
- dev_info(dev, "doesn't support gadget\n");
+ if (dr_mode == USB_DR_MODE_OTG || dr_mode == USB_DR_MODE_PERIPHERAL) {
+ ret = ci_hdrc_gadget_init(ci);
+ if (ret)
+ dev_info(dev, "doesn't support gadget\n");
+ }
if (!ci->roles[CI_ROLE_HOST] && !ci->roles[CI_ROLE_GADGET]) {
dev_err(dev, "no supported roles\n");
@@ -20,7 +20,7 @@ struct ci13xxx_platform_data {
#define CI13XXX_REQUIRE_TRANSCEIVER BIT(1)
#define CI13XXX_PULLUP_ON_VBUS BIT(2)
#define CI13XXX_DISABLE_STREAMING BIT(3)
-
+ enum usb_dr_mode dr_mode;
#define CI13XXX_CONTROLLER_RESET_EVENT 0
#define CI13XXX_CONTROLLER_STOPPED_EVENT 1
void (*notify_event) (struct ci13xxx *ci, unsigned event);
Even if a chipidea core is otg capable the board may not. This allows to explicitly set the core to host/peripheral mode. Without these flags the driver falls back to the old behaviour. Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de> --- drivers/usb/chipidea/core.c | 21 +++++++++++++++------ include/linux/usb/chipidea.h | 2 +- 2 files changed, 16 insertions(+), 7 deletions(-)