diff mbox

[4/4] mtd: gpmi: imx6: fix the wrong method for checking ready/busy

Message ID 1371197185-27491-5-git-send-email-b32955@freescale.com (mailing list archive)
State New, archived
Headers show

Commit Message

Huang Shijie June 14, 2013, 8:06 a.m. UTC 
In the imx6, all the ready/busy pins are binding togeter.
So we only need to check the chip 0 busy status.

For example, When the CS1 is enabled, we also should check the
ready/busy of chip 0, if we check the ready/busy of chip 1,
we will get the wrong result.

Signed-off-by: Huang Shijie <b32955@freescale.com>
---
 drivers/mtd/nand/gpmi-nand/gpmi-lib.c |    8 ++++++++
 1 files changed, 8 insertions(+), 0 deletions(-)
diff mbox

Patch

diff --git a/drivers/mtd/nand/gpmi-nand/gpmi-lib.c b/drivers/mtd/nand/gpmi-nand/gpmi-lib.c
index 7d56d87..660c5d7 100644
--- a/drivers/mtd/nand/gpmi-nand/gpmi-lib.c
+++ b/drivers/mtd/nand/gpmi-nand/gpmi-lib.c
@@ -1079,6 +1079,14 @@  int gpmi_is_ready(struct gpmi_nand_data *this, unsigned chip)
 		mask = MX23_BM_GPMI_DEBUG_READY0 << chip;
 		reg = readl(r->gpmi_regs + HW_GPMI_DEBUG);
 	} else if (GPMI_IS_MX28(this) || GPMI_IS_MX6Q(this)) {
+		/*
+		 * In the imx6, all the ready/busy pins are binding
+		 * togeter. So we only need to check the ready/busy status
+		 * of chip 0.
+		 */
+		if (GPMI_IS_MX6Q(this))
+			chip = 0;
+
 		/* MX28 shares the same R/B register as MX6Q. */
 		mask = MX28_BF_GPMI_STAT_READY_BUSY(1 << chip);
 		reg = readl(r->gpmi_regs + HW_GPMI_STAT);