@@ -679,9 +679,7 @@ __armv4_mmu_cache_on:
mrc p15, 0, r0, c1, c0, 0 @ read control reg
orr r0, r0, #0x5000 @ I-cache enable, RR cache replacement
orr r0, r0, #0x0030
-#ifdef CONFIG_CPU_ENDIAN_BE8
- orr r0, r0, #1 << 25 @ big-endian page tables
-#endif
+ ARM_BE8( orr r0, r0, #1 << 25 ) @ big-endian page tables
bl __common_mmu_cache_on
mov r0, #0
mcr p15, 0, r0, c8, c7, 0 @ flush I,D TLBs
@@ -708,9 +706,7 @@ __armv7_mmu_cache_on:
orr r0, r0, #1 << 22 @ U (v6 unaligned access model)
@ (needed for ARM1176)
#ifdef CONFIG_MMU
-#ifdef CONFIG_CPU_ENDIAN_BE8
- orr r0, r0, #1 << 25 @ big-endian page tables
-#endif
+ ARM_BE8( orr r0, r0, #1 << 25 ) @ big-endian page tables
mrcne p15, 0, r6, c2, c0, 2 @ read ttb control reg
orrne r0, r0, #1 @ MMU enabled
movne r1, #0xfffffffd @ domain 0 = client
@@ -53,6 +53,13 @@
#define put_byte_3 lsl #0
#endif
+/* Select code for any configuration running in BE8 mode */
+#ifdef CONFIG_CPU_ENDIAN_BE8
+#define ARM_BE8(code...) code
+#else
+#define ARM_BE8(code...)
+#endif
+
/*
* Data preload for architectures that support it
*/
@@ -415,9 +415,8 @@ __und_usr:
bne __und_usr_thumb
sub r4, r2, #4 @ ARM instr at LR - 4
1: ldrt r0, [r4]
-#ifdef CONFIG_CPU_ENDIAN_BE8
- rev r0, r0 @ little endian instruction
-#endif
+ ARM_BE8(rev r0, r0) @ little endian instruction
+
@ r0 = 32-bit ARM instruction which caused the exception
@ r2 = PC value for the following instruction (:= regs->ARM_pc)
@ r4 = PC value for the faulting instruction
@@ -379,9 +379,7 @@ ENTRY(vector_swi)
#else
ldr r10, [lr, #-4] @ get SWI instruction
#endif
-#ifdef CONFIG_CPU_ENDIAN_BE8
- rev r10, r10 @ little endian instruction
-#endif
+ ARM_BE8(rev r10, r10) @ little endian instruction
#elif defined(CONFIG_AEABI)
@@ -38,9 +38,8 @@ ENTRY(v6_early_abort)
bne do_DataAbort
bic r1, r1, #1 << 11 @ clear bit 11 of FSR
ldr r3, [r4] @ read aborted ARM instruction
-#ifdef CONFIG_CPU_ENDIAN_BE8
- rev r3, r3
-#endif
+ ARM_BE8(rev r3, r3)
+
do_ldrd_abort tmp=ip, insn=r3
tst r3, #1 << 20 @ L = 0 -> write
orreq r1, r1, #1 << 11 @ yes.
@@ -218,9 +218,7 @@ __v6_setup:
#endif /* CONFIG_MMU */
adr r5, v6_crval
ldmia r5, {r5, r6}
-#ifdef CONFIG_CPU_ENDIAN_BE8
- orr r6, r6, #1 << 25 @ big-endian page tables
-#endif
+ ARM_BE8(orr r6, r6, #1 << 25) @ big-endian page tables
mrc p15, 0, r0, c1, c0, 0 @ read control register
bic r0, r0, r5 @ clear bits them
orr r0, r0, r6 @ set them
@@ -328,9 +328,7 @@ __v7_setup:
#endif
adr r5, v7_crval
ldmia r5, {r5, r6}
-#ifdef CONFIG_CPU_ENDIAN_BE8
- orr r6, r6, #1 << 25 @ big-endian page tables
-#endif
+ ARM_BE8(orr r6, r6, #1 << 25) @ big-endian page tables
#ifdef CONFIG_SWP_EMULATE
orr r5, r5, #(1 << 10) @ set SW bit in "clear"
bic r6, r6, #(1 << 10) @ clear it in "mmuset"