| Message ID | 1387242783-1462-7-git-send-email-troy.kisky@boundarydevices.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
diff --git a/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi b/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi index 2654ff1..ee3f5c0 100644 --- a/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi +++ b/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi @@ -114,7 +114,6 @@ imx6q-sabrelite { pinctrl_hog: hoggrp { fsl,pins = < - MX6QDL_PAD_EIM_D23__GPIO3_IO23 0x80000000 MX6QDL_PAD_GPIO_0__CCM_CLKO1 0x80000000 >; }; @@ -131,7 +130,11 @@ }; pinctrl_enet: enetgrp { - fsl,pins = <MX6QDL_ENET_PINGRP1>; + fsl,pins = < + MX6QDL_ENET_PINGRP1 + /* Phy reset */ + MX6QDL_PAD_EIM_D23__GPIO3_IO23 0x000b0 + >; }; pinctrl_i2c1: i2c1grp {
This patch moves pin EIM_D23 (phy reset) from pinctrl_hog to pinctrl_enet. It also explicitly sets the pad to 0x000b0. Before this patch, it has the value 0x1b0b0 if using mainline u-boot. So this patch also removes hysteresis and a 100K pullup since the pad is always an output. Signed-off-by: Troy Kisky <troy.kisky@boundarydevices.com> --- v2: New patch.. V1 patch to add comments was broken up into multiple patches --- arch/arm/boot/dts/imx6qdl-sabrelite.dtsi | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-)