@@ -12,6 +12,8 @@ dtb-$(CONFIG_ARCH_AT91) += ethernut5.dtb
dtb-$(CONFIG_ARCH_AT91) += evk-pro3.dtb
dtb-$(CONFIG_ARCH_AT91) += tny_a9260.dtb
dtb-$(CONFIG_ARCH_AT91) += usb_a9260.dtb
+# sam9261
+dtb-$(CONFIG_ARCH_AT91) += at91sam9261ek.dtb
# sam9263
dtb-$(CONFIG_ARCH_AT91) += at91sam9263ek.dtb
dtb-$(CONFIG_ARCH_AT91) += tny_a9263.dtb
new file mode 100644
@@ -0,0 +1,204 @@
+/*
+ * at91sam9261ek.dts - Device Tree file for Atmel at91sam9261 reference board
+ *
+ * Copyright (C) 2013 Jean-Jacques Hiblot <jjhiblot@traphandler.com>
+ *
+ * Licensed under GPLv2 only.
+ */
+/dts-v1/;
+#include "at91sam9261.dtsi"
+
+/ {
+ model = "Atmel at91sam9261ek";
+ compatible = "atmel,at91sam9261ek", "atmel,at91sam9261", "atmel,at91sam9";
+
+ chosen {
+ bootargs = "console=ttyS0,115200 rootfstype=ubifs ubi.mtd=5 root=ubi0:rootfs rw";
+ };
+
+ memory {
+ reg = <0x20000000 0x4000000>;
+ };
+
+ clocks {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+
+ main_clock: clock@0 {
+ compatible = "atmel,osc", "fixed-clock";
+ clock-frequency = <18432000>;
+ };
+ };
+
+ ahb {
+ usb0: ohci@00500000 {
+ status = "okay";
+ };
+
+ fb0: fb@0x00600000 {
+ display = <&display0>;
+ atmel,power-control-gpio = <&pioA 12 GPIO_ACTIVE_LOW>;
+ status = "okay";
+
+ display0: display {
+ bits-per-pixel = <16>;
+ atmel,lcdcon-backlight;
+ atmel,dmacon = <0x1>;
+ atmel,lcdcon2 = <0x80008002>;
+ atmel,guard-time = <1>;
+ atmel,lcd-wiring-mode = "BRG";
+
+ display-timings {
+ native-mode = <&timing0>;
+ timing0: timing0 {
+ clock-frequency = <4965000>;
+ hactive = <240>;
+ vactive = <320>;
+ hback-porch = <1>;
+ hfront-porch = <33>;
+ vback-porch = <1>;
+ vfront-porch = <0>;
+ hsync-len = <5>;
+ vsync-len = <1>;
+ hsync-active = <1>;
+ vsync-active = <1>;
+ };
+ };
+ };
+ };
+
+ nand0: nand@40000000 {
+ nand-bus-width = <8>;
+ nand-ecc-mode = "soft";
+ nand-on-flash-bbt;
+ status = "okay";
+
+ at91bootstrap@0 {
+ label = "at91bootstrap";
+ reg = <0x0 0x40000>;
+ };
+
+ bootloader@40000 {
+ label = "bootloader";
+ reg = <0x40000 0x80000>;
+ };
+
+ bootloaderenv@c0000 {
+ label = "bootloader env";
+ reg = <0xc0000 0xc0000>;
+ };
+
+ dtb@180000 {
+ label = "device tree";
+ reg = <0x180000 0x80000>;
+ };
+
+ kernel@200000 {
+ label = "kernel";
+ reg = <0x200000 0x600000>;
+ };
+
+ rootfs@800000 {
+ label = "rootfs";
+ reg = <0x800000 0x0f800000>;
+ };
+ };
+
+ apb {
+ usb1: gadget@fffa4000 {
+ atmel,vbus-gpio = <&pioB 29 GPIO_ACTIVE_HIGH>;
+ status = "okay";
+ };
+ spi0: spi@fffc8000 {
+ cs-gpios = <&pioA 3 0>, <0>, <&pioA 28 0>, <0>;
+ status = "okay";
+
+ mtd_dataflash@0 {
+ compatible = "atmel,at45", "atmel,dataflash";
+ reg = <0>;
+ spi-max-frequency = <15000000>;
+ };
+ tsc2046@0 {
+ reg = <2>;
+ compatible = "ti,ads7843";
+ interrupts-extended = <&pioC 2 IRQ_TYPE_EDGE_BOTH>;
+ spi-max-frequency = <3000000>;
+ pendown-gpio = <&pioC 2 GPIO_ACTIVE_HIGH>;
+
+ ti,x-min = /bits/ 16 <150>;
+ ti,x-max = /bits/ 16 <3830>;
+ ti,y-min = /bits/ 16 <190>;
+ ti,y-max = /bits/ 16 <3830>;
+ ti,vref-delay-usecs = /bits/ 16 <450>;
+ ti,x-plate-ohms = /bits/ 16 <450>;
+ ti,y-plate-ohms = /bits/ 16 <250>;
+ ti,pressure-max = /bits/ 16 <15000>;
+ ti,debounce-rep = /bits/ 16 <0>;
+ ti,debounce-tol = /bits/ 16 <65535>;
+ ti,debounce-max = /bits/ 16 <1>;
+
+ linux,wakeup;
+ };
+ };
+
+ dbgu: serial@fffff200 {
+ status = "okay";
+ };
+
+ watchdog@fffffd40 {
+ status = "okay";
+ };
+
+ };
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ ds8 {
+ label = "ds8";
+ gpios = <&pioA 13 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "none";
+ };
+ ds7 {
+ label = "ds7";
+ gpios = <&pioA 14 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "nand-disk";
+ };
+ ds1 {
+ label = "ds1";
+ gpios = <&pioA 23 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "heartbeat";
+ };
+ };
+
+ gpio_keys {
+ compatible = "gpio-keys";
+
+ button_0 {
+ label = "button_0";
+ gpios = <&pioA 27 GPIO_ACTIVE_LOW>;
+ linux,code = <256>;
+ gpio-key,wakeup;
+ };
+ button_1 {
+ label = "button_1";
+ gpios = <&pioA 26 GPIO_ACTIVE_LOW>;
+ linux,code = <257>;
+ gpio-key,wakeup;
+ };
+ button_2 {
+ label = "button_2";
+ gpios = <&pioA 25 GPIO_ACTIVE_LOW>;
+ linux,code = <258>;
+ gpio-key,wakeup;
+ };
+ button_3 {
+ label = "button_3";
+ gpios = <&pioA 24 GPIO_ACTIVE_LOW>;
+ linux,code = <259>;
+ gpio-key,wakeup;
+ };
+ };
+};
This patch implements a DTS to boot a at91sam9261ek with a dt-enabled kernel (at91_dt_defconfig). supported features are: * dbgu * lcdc * usb host * usb gadget, * spi dataflash * nand flash * touchscreen * leds * user buttons In the TODO list: * dm9000 (ethernet) * audio * mmc Signed-off-by: Jean-Jacques Hiblot <jjhiblot@traphandler.com> --- arch/arm/boot/dts/Makefile | 2 + arch/arm/boot/dts/at91sam9261ek.dts | 204 ++++++++++++++++++++++++++++++++++++ 2 files changed, 206 insertions(+) create mode 100644 arch/arm/boot/dts/at91sam9261ek.dts