@@ -54,6 +54,7 @@ source "drivers/net/ethernet/neterion/Kconfig"
source "drivers/net/ethernet/faraday/Kconfig"
source "drivers/net/ethernet/freescale/Kconfig"
source "drivers/net/ethernet/fujitsu/Kconfig"
+source "drivers/net/ethernet/hisilicon/Kconfig"
source "drivers/net/ethernet/hp/Kconfig"
source "drivers/net/ethernet/ibm/Kconfig"
source "drivers/net/ethernet/intel/Kconfig"
@@ -29,6 +29,7 @@ obj-$(CONFIG_NET_VENDOR_EXAR) += neterion/
obj-$(CONFIG_NET_VENDOR_FARADAY) += faraday/
obj-$(CONFIG_NET_VENDOR_FREESCALE) += freescale/
obj-$(CONFIG_NET_VENDOR_FUJITSU) += fujitsu/
+obj-$(CONFIG_NET_VENDOR_HISILICON) += hisilicon/
obj-$(CONFIG_NET_VENDOR_HP) += hp/
obj-$(CONFIG_NET_VENDOR_IBM) += ibm/
obj-$(CONFIG_NET_VENDOR_INTEL) += intel/
new file mode 100644
@@ -0,0 +1,31 @@
+#
+# HISILICON device configuration
+#
+
+config NET_VENDOR_HISILICON
+ bool "Hisilicon devices"
+ default y
+ depends on ARM
+ ---help---
+ If you have a network (Ethernet) card belonging to this class, say Y
+ and read the Ethernet-HOWTO, available from
+ <http://www.tldp.org/docs.html#howto>.
+
+ Note that the answer to this question doesn't directly affect the
+ kernel: saying N will just cause the configurator to skip all
+ the questions about Hisilicon devices. If you say Y, you will be asked
+ for your specific card in the following questions.
+
+if NET_VENDOR_HISILICON
+
+config HIP04_ETH
+ tristate "HISILICON P04 Ethernet support"
+ select PHYLIB
+ select MARVELL_PHY
+ select MFD_SYSCON
+ ---help---
+ If you wish to compile a kernel for a hardware with hisilicon p04 SoC and
+ want to use the internal ethernet then you should answer Y to this.
+
+
+endif # NET_VENDOR_HISILICON
new file mode 100644
@@ -0,0 +1,5 @@
+#
+# Makefile for the HISILICON network device drivers.
+#
+
+obj-$(CONFIG_HIP04_ETH) += hip04_mdio.o
new file mode 100644
@@ -0,0 +1,186 @@
+
+/* Copyright (c) 2014 Linaro Ltd.
+ * Copyright (c) 2014 Hisilicon Limited.
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License as published by
+ * the Free Software Foundation; either version 2 of the License, or
+ * (at your option) any later version.
+ */
+
+#include <linux/module.h>
+#include <linux/platform_device.h>
+#include <linux/io.h>
+#include <linux/of_mdio.h>
+#include <linux/delay.h>
+
+#define MDIO_CMD_REG 0x0
+#define MDIO_ADDR_REG 0x4
+#define MDIO_WDATA_REG 0x8
+#define MDIO_RDATA_REG 0xc
+#define MDIO_STA_REG 0x10
+
+#define MDIO_START BIT(14)
+#define MDIO_R_VALID BIT(1)
+#define MDIO_READ (BIT(12) | BIT(11) | MDIO_START)
+#define MDIO_WRITE (BIT(12) | BIT(10) | MDIO_START)
+
+struct hip04_mdio_priv {
+ void __iomem *base;
+};
+
+#define WAIT_TIMEOUT 10
+static int hip04_mdio_wait_ready(struct mii_bus *bus)
+{
+ struct hip04_mdio_priv *priv = bus->priv;
+ int i;
+
+ for (i = 0; readl_relaxed(priv->base + MDIO_CMD_REG) & MDIO_START; i++) {
+ if (i == WAIT_TIMEOUT)
+ return -ETIMEDOUT;
+ msleep(20);
+ }
+
+ return 0;
+}
+
+static int hip04_mdio_read(struct mii_bus *bus, int mii_id, int regnum)
+{
+ struct hip04_mdio_priv *priv = bus->priv;
+ u32 val;
+ int ret;
+
+ ret = hip04_mdio_wait_ready(bus);
+ if (ret < 0)
+ goto out;
+
+ val = regnum | (mii_id << 5) | MDIO_READ;
+ writel_relaxed(val, priv->base + MDIO_CMD_REG);
+
+ ret = hip04_mdio_wait_ready(bus);
+ if (ret < 0)
+ goto out;
+
+ val = readl_relaxed(priv->base + MDIO_STA_REG);
+ if (val & MDIO_R_VALID) {
+ dev_err(bus->parent, "SMI bus read not valid\n");
+ ret = -ENODEV;
+ goto out;
+ }
+
+ val = readl_relaxed(priv->base + MDIO_RDATA_REG);
+ ret = val & 0xFFFF;
+out:
+ return ret;
+}
+
+static int hip04_mdio_write(struct mii_bus *bus, int mii_id,
+ int regnum, u16 value)
+{
+ struct hip04_mdio_priv *priv = bus->priv;
+ u32 val;
+ int ret;
+
+ ret = hip04_mdio_wait_ready(bus);
+ if (ret < 0)
+ goto out;
+
+ writel_relaxed(value, priv->base + MDIO_WDATA_REG);
+ val = regnum | (mii_id << 5) | MDIO_WRITE;
+ writel_relaxed(val, priv->base + MDIO_CMD_REG);
+out:
+ return ret;
+}
+
+
+static int hip04_mdio_reset(struct mii_bus *bus)
+{
+ int temp, err, i;
+
+ for (i = 0; i < PHY_MAX_ADDR; i++) {
+ hip04_mdio_write(bus, i, 22, 0);
+ temp = hip04_mdio_read(bus, i, MII_BMCR);
+ temp |= BMCR_RESET;
+ err = hip04_mdio_write(bus, i, MII_BMCR, temp);
+ if (err < 0)
+ return err;
+ }
+
+ mdelay(500);
+ return 0;
+}
+
+static int hip04_mdio_probe(struct platform_device *pdev)
+{
+ struct resource *r;
+ struct mii_bus *bus;
+ struct hip04_mdio_priv *priv;
+ int ret;
+
+ bus = mdiobus_alloc_size(sizeof(struct hip04_mdio_priv));
+ if (!bus) {
+ dev_err(&pdev->dev, "Cannot allocate MDIO bus\n");
+ return -ENOMEM;
+ }
+
+ bus->name = "hip04_mdio_bus";
+ bus->read = hip04_mdio_read;
+ bus->write = hip04_mdio_write;
+ bus->reset = hip04_mdio_reset;
+ snprintf(bus->id, MII_BUS_ID_SIZE, "%s-mii", dev_name(&pdev->dev));
+ bus->parent = &pdev->dev;
+ priv = bus->priv;
+
+ r = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+ priv->base = devm_ioremap_resource(&pdev->dev, r);
+ if (IS_ERR(priv->base)) {
+ ret = PTR_ERR(priv->base);
+ goto out_mdio;
+ }
+
+ ret = of_mdiobus_register(bus, pdev->dev.of_node);
+ if (ret < 0) {
+ dev_err(&pdev->dev, "Cannot register MDIO bus (%d)\n", ret);
+ goto out_mdio;
+ }
+
+ platform_set_drvdata(pdev, bus);
+
+ return 0;
+
+out_mdio:
+ mdiobus_free(bus);
+ return ret;
+}
+
+static int hip04_mdio_remove(struct platform_device *pdev)
+{
+ struct mii_bus *bus = platform_get_drvdata(pdev);
+
+ mdiobus_unregister(bus);
+ mdiobus_free(bus);
+
+ return 0;
+}
+
+static const struct of_device_id hip04_mdio_match[] = {
+ { .compatible = "hisilicon,hip04-mdio" },
+ { }
+};
+MODULE_DEVICE_TABLE(of, hip04_mdio_match);
+
+static struct platform_driver hip04_mdio_driver = {
+ .probe = hip04_mdio_probe,
+ .remove = hip04_mdio_remove,
+ .driver = {
+ .name = "hip04-mdio",
+ .owner = THIS_MODULE,
+ .of_match_table = hip04_mdio_match,
+ },
+};
+
+module_platform_driver(hip04_mdio_driver);
+
+MODULE_DESCRIPTION("HISILICON P04 MDIO interface driver");
+MODULE_LICENSE("GPL v2");
+MODULE_ALIAS("platform:hip04-mdio");
Hisilicon hip04 platform mdio driver Reuse Marvell phy drivers/net/phy/marvell.c Signed-off-by: Zhangfei Gao <zhangfei.gao@linaro.org> --- drivers/net/ethernet/Kconfig | 1 + drivers/net/ethernet/Makefile | 1 + drivers/net/ethernet/hisilicon/Kconfig | 31 +++++ drivers/net/ethernet/hisilicon/Makefile | 5 + drivers/net/ethernet/hisilicon/hip04_mdio.c | 186 +++++++++++++++++++++++++++ 5 files changed, 224 insertions(+) create mode 100644 drivers/net/ethernet/hisilicon/Kconfig create mode 100644 drivers/net/ethernet/hisilicon/Makefile create mode 100644 drivers/net/ethernet/hisilicon/hip04_mdio.c