@@ -25,6 +25,11 @@
"google,pit", "google,peach","samsung,exynos5420",
"samsung,exynos5";
+ aliases {
+ /* Assign 20 so we don't get confused w/ builtin ones */
+ i2c20 = "/spi@12d40000/cros-ec@0/i2c-tunnel";
+ };
+
memory {
reg = <0x20000000 0x80000000>;
};
@@ -87,6 +92,13 @@
pinctrl-0 = <&usb301_vbus_en>;
enable-active-high;
};
+
+ vbat: fixed-regulator {
+ compatible = "regulator-fixed";
+ regulator-name = "vbat-supply";
+ regulator-boot-on;
+ regulator-always-on;
+ };
};
&pinctrl_0 {
@@ -111,6 +123,20 @@
samsung,pin-drv = <0>;
};
+ ec_irq: ec-irq {
+ samsung,pins = "gpx1-5";
+ samsung,pin-function = <0>;
+ samsung,pin-pud = <0>;
+ samsung,pin-drv = <0>;
+ };
+
+ tps65090_irq: tps65090-irq {
+ samsung,pins = "gpx2-5";
+ samsung,pin-function = <0>;
+ samsung,pin-pud = <0>;
+ samsung,pin-drv = <0>;
+ };
+
hdmi_hpd_irq: hdmi-hpd-irq {
samsung,pins = "gpx3-7";
samsung,pin-function = <0>;
@@ -127,6 +153,19 @@
};
&pinctrl_3 {
+ /* Drive SPI lines at x2 for better integrity */
+ spi2-bus {
+ samsung,pin-drv = <2>;
+ };
+
+ /* Drive SPI chip select at x2 for better integrity */
+ ec_spi_cs: ec-spi-cs {
+ samsung,pins = "gpb1-2";
+ samsung,pin-function = <1>;
+ samsung,pin-pud = <0>;
+ samsung,pin-drv = <2>;
+ };
+
usb300_vbus_en: usb300-vbus-en {
samsung,pins = "gph0-0";
samsung,pin-function = <1>;
@@ -189,6 +228,111 @@
};
};
+&spi_2 {
+ status = "okay";
+ num-cs = <1>;
+ samsung,spi-src-clk = <0>;
+ cs-gpios = <&gpb1 2 0>;
+
+ cros_ec: cros-ec@0 {
+ compatible = "google,cros-ec-spi";
+ interrupt-parent = <&gpx1>;
+ interrupts = <5 0>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&ec_spi_cs &ec_irq>;
+ reg = <0>;
+ spi-max-frequency = <3125000>;
+
+ controller-data {
+ samsung,spi-feedback-delay = <1>;
+ };
+
+ i2c-tunnel {
+ compatible = "google,cros-ec-i2c-tunnel";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ google,remote-bus = <0>;
+
+ battery: sbs-battery@b {
+ compatible = "sbs,sbs-battery";
+ reg = <0xb>;
+ sbs,poll-retry-count = <1>;
+ sbs,i2c-retry-count = <2>;
+ };
+
+ power-regulator@48 {
+ compatible = "ti,tps65090";
+ reg = <0x48>;
+
+ /*
+ * Config irq to disable internal pulls
+ * even though we run in polling mode.
+ */
+ pinctrl-names = "default";
+ pinctrl-0 = <&tps65090_irq>;
+
+ vsys1-supply = <&vbat>;
+ vsys2-supply = <&vbat>;
+ vsys3-supply = <&vbat>;
+ infet1-supply = <&vbat>;
+ infet2-supply = <&vbat>;
+ infet3-supply = <&vbat>;
+ infet4-supply = <&vbat>;
+ infet5-supply = <&vbat>;
+ infet6-supply = <&vbat>;
+ infet7-supply = <&vbat>;
+ vsys-l1-supply = <&vbat>;
+ vsys-l2-supply = <&vbat>;
+
+ regulators {
+ dcdc1 {
+ ti,enable-ext-control;
+ };
+ dcdc2 {
+ ti,enable-ext-control;
+ };
+ dcdc3 {
+ ti,enable-ext-control;
+ };
+ fet1 {
+ regulator-name = "vcd_led";
+ };
+ tps65090_fet2: fet2 {
+ regulator-name = "video_mid";
+ regulator-always-on;
+ };
+ fet3 {
+ regulator-name = "wwan_r";
+ regulator-always-on;
+ };
+ fet4 {
+ regulator-name = "sdcard";
+ regulator-always-on;
+ };
+ fet5 {
+ regulator-name = "camout";
+ };
+ fet6 {
+ regulator-name = "lcd_vdd";
+ };
+ tps65090_fet7: fet7 {
+ regulator-name = "video_mid_1a";
+ regulator-always-on;
+ };
+ ldo1 {
+ };
+ ldo2 {
+ };
+ };
+
+ charger {
+ compatible = "ti,tps65090-charger";
+ };
+ };
+ };
+ };
+};
+
&hsi2c_7 {
status = "okay";
@@ -285,3 +429,5 @@
};
};
};
+
+#include "cros-ec-keyboard.dtsi"
@@ -23,6 +23,11 @@
"google,pi", "google,peach", "samsung,exynos5800",
"samsung,exynos5";
+ aliases {
+ /* Assign 20 so we don't get confused w/ builtin ones */
+ i2c20 = "/spi@12d40000/cros-ec@0/i2c-tunnel";
+ };
+
memory {
reg = <0x20000000 0x80000000>;
};
@@ -78,6 +83,13 @@
pinctrl-0 = <&usb301_vbus_en>;
enable-active-high;
};
+
+ vbat: fixed-regulator {
+ compatible = "regulator-fixed";
+ regulator-name = "vbat-supply";
+ regulator-boot-on;
+ regulator-always-on;
+ };
};
&pinctrl_0 {
@@ -102,6 +114,20 @@
samsung,pin-drv = <0>;
};
+ ec_irq: ec-irq {
+ samsung,pins = "gpx1-5";
+ samsung,pin-function = <0>;
+ samsung,pin-pud = <0>;
+ samsung,pin-drv = <0>;
+ };
+
+ tps65090_irq: tps65090-irq {
+ samsung,pins = "gpx2-5";
+ samsung,pin-function = <0>;
+ samsung,pin-pud = <0>;
+ samsung,pin-drv = <0>;
+ };
+
hdmi_hpd_irq: hdmi-hpd-irq {
samsung,pins = "gpx3-7";
samsung,pin-function = <0>;
@@ -111,6 +137,19 @@
};
&pinctrl_3 {
+ /* Drive SPI lines at x2 for better integrity */
+ spi2-bus {
+ samsung,pin-drv = <2>;
+ };
+
+ /* Drive SPI chip select at x2 for better integrity */
+ ec_spi_cs: ec-spi-cs {
+ samsung,pins = "gpb1-2";
+ samsung,pin-function = <1>;
+ samsung,pin-pud = <0>;
+ samsung,pin-drv = <2>;
+ };
+
usb300_vbus_en: usb300-vbus-en {
samsung,pins = "gph0-0";
samsung,pin-function = <1>;
@@ -173,6 +212,111 @@
};
};
+&spi_2 {
+ status = "okay";
+ num-cs = <1>;
+ samsung,spi-src-clk = <0>;
+ cs-gpios = <&gpb1 2 0>;
+
+ cros_ec: cros-ec@0 {
+ compatible = "google,cros-ec-spi";
+ interrupt-parent = <&gpx1>;
+ interrupts = <5 0>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&ec_spi_cs &ec_irq>;
+ reg = <0>;
+ spi-max-frequency = <3125000>;
+
+ controller-data {
+ samsung,spi-feedback-delay = <1>;
+ };
+
+ i2c-tunnel {
+ compatible = "google,cros-ec-i2c-tunnel";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ google,remote-bus = <0>;
+
+ battery: sbs-battery@b {
+ compatible = "sbs,sbs-battery";
+ reg = <0xb>;
+ sbs,poll-retry-count = <1>;
+ sbs,i2c-retry-count = <2>;
+ };
+
+ power-regulator@48 {
+ compatible = "ti,tps65090";
+ reg = <0x48>;
+
+ /*
+ * Config irq to disable internal pulls
+ * even though we run in polling mode.
+ */
+ pinctrl-names = "default";
+ pinctrl-0 = <&tps65090_irq>;
+
+ vsys1-supply = <&vbat>;
+ vsys2-supply = <&vbat>;
+ vsys3-supply = <&vbat>;
+ infet1-supply = <&vbat>;
+ infet2-supply = <&vbat>;
+ infet3-supply = <&vbat>;
+ infet4-supply = <&vbat>;
+ infet5-supply = <&vbat>;
+ infet6-supply = <&vbat>;
+ infet7-supply = <&vbat>;
+ vsys-l1-supply = <&vbat>;
+ vsys-l2-supply = <&vbat>;
+
+ regulators {
+ dcdc1 {
+ ti,enable-ext-control;
+ };
+ dcdc2 {
+ ti,enable-ext-control;
+ };
+ dcdc3 {
+ ti,enable-ext-control;
+ };
+ fet1 {
+ regulator-name = "vcd_led";
+ };
+ tps65090_fet2: fet2 {
+ regulator-name = "video_mid";
+ regulator-always-on;
+ };
+ fet3 {
+ regulator-name = "wwan_r";
+ regulator-always-on;
+ };
+ fet4 {
+ regulator-name = "sdcard";
+ regulator-always-on;
+ };
+ fet5 {
+ regulator-name = "camout";
+ };
+ fet6 {
+ regulator-name = "lcd_vdd";
+ };
+ tps65090_fet7: fet7 {
+ regulator-name = "video_mid_1a";
+ regulator-always-on;
+ };
+ ldo1 {
+ };
+ ldo2 {
+ };
+ };
+
+ charger {
+ compatible = "ti,tps65090-charger";
+ };
+ };
+ };
+ };
+};
+
&dp {
status = "okay";
pinctrl-names = "default";
@@ -251,3 +395,5 @@
&watchdog {
timeout-sec = <32>;
};
+
+#include "cros-ec-keyboard.dtsi"
This adds cros_ec to exynos5420-peach-pit and exynos5800-peach-pi, including: * The keyboard * The i2c tunnel * The tps65090 under the i2c tunnel * The battery under the i2c tunnel To add extra motivation, it should be noted that tps65090 is one of the things needed to get display-related FETs turned on for pit and pi. Note that this relies on a few outstanding changes: * Needs "cros-ec-keyboard.dtsi" in order to compile properly. See (ARM: dts: Create a cros-ec-keyboard fragment) at <https://patchwork.kernel.org/patch/4297451/>. * Needs (mfd: cros_ec: spi: Fix end of transfer on devices with no spi-msg-delay) from this series to work properly. * Needs (spi: s3c64xx: fix broken "cs_gpios" usage in the driver) and (spi: s3c64xx: for DT platofrms always get the chipselect info from DT node) to work properly and match the documented bindings. See <https://patchwork.kernel.org/patch/4346701/> and <https://patchwork.kernel.org/patch/4346711/> Signed-off-by: Doug Anderson <dianders@chromium.org> --- arch/arm/boot/dts/exynos5420-peach-pit.dts | 146 +++++++++++++++++++++++++++++ arch/arm/boot/dts/exynos5800-peach-pi.dts | 146 +++++++++++++++++++++++++++++ 2 files changed, 292 insertions(+)