@@ -39,6 +39,7 @@
#include <linux/slab.h>
#include <linux/irqchip/chained_irq.h>
#include <linux/irqchip/arm-gic.h>
+#include <linux/ratelimit.h>
#include <asm/cputype.h>
#ifdef CONFIG_FIQ
@@ -51,6 +52,10 @@
#include "irq-gic-common.h"
#include "irqchip.h"
+#ifndef SMP_IPI_FIQ_MASK
+#define SMP_IPI_FIQ_MASK 0
+#endif
+
union gic_base {
void __iomem *common_base;
void __percpu * __iomem *percpu_base;
@@ -77,6 +82,8 @@ struct gic_chip_data {
};
static DEFINE_RAW_SPINLOCK(irq_controller_lock);
+/* A fiq-safe spinlock must only be locked when the FIQ is masked */
+static DEFINE_RAW_SPINLOCK(fiq_safe_migration_lock);
/*
* The GIC mapping of CPU interfaces does not necessarily match
@@ -346,20 +353,21 @@ static struct irq_chip gic_chip = {
* match what "ARM strongly recommends" for a system where no Group 1
* interrupt must ever preempt a Group 0 interrupt.
*/
-static void gic_set_group_irq(struct irq_data *d, int group)
+static void gic_set_group_irq(void __iomem *base, unsigned int hwirq,
+ int group)
{
- unsigned int grp_reg = gic_irq(d) / 32 * 4;
- u32 grp_mask = 1 << (gic_irq(d) % 32);
+ unsigned int grp_reg = hwirq / 32 * 4;
+ u32 grp_mask = 1 << (hwirq % 32);
u32 grp_val;
- unsigned int pri_reg = (gic_irq(d) / 4) * 4;
- u32 pri_mask = 1 << (7 + ((gic_irq(d) % 4) * 8));
+ unsigned int pri_reg = (hwirq / 4) * 4;
+ u32 pri_mask = 1 << (7 + ((hwirq % 4) * 8));
u32 pri_val;
raw_spin_lock(&irq_controller_lock);
- grp_val = readl_relaxed(gic_dist_base(d) + GIC_DIST_IGROUP + grp_reg);
- pri_val = readl_relaxed(gic_dist_base(d) + GIC_DIST_PRI + pri_reg);
+ grp_val = readl_relaxed(base + GIC_DIST_IGROUP + grp_reg);
+ pri_val = readl_relaxed(base + GIC_DIST_PRI + pri_reg);
if (group) {
grp_val |= grp_mask;
@@ -369,20 +377,20 @@ static void gic_set_group_irq(struct irq_data *d, int group)
pri_val &= ~pri_mask;
}
- writel_relaxed(grp_val, gic_dist_base(d) + GIC_DIST_IGROUP + grp_reg);
- writel_relaxed(pri_val, gic_dist_base(d) + GIC_DIST_PRI + pri_reg);
+ writel_relaxed(grp_val, base + GIC_DIST_IGROUP + grp_reg);
+ writel_relaxed(pri_val, base + GIC_DIST_PRI + pri_reg);
raw_spin_unlock(&irq_controller_lock);
}
static void gic_enable_fiq(struct irq_data *d)
{
- gic_set_group_irq(d, 0);
+ gic_set_group_irq(gic_dist_base(d), gic_irq(d), 0);
}
static void gic_disable_fiq(struct irq_data *d)
{
- gic_set_group_irq(d, 1);
+ gic_set_group_irq(gic_dist_base(d), gic_irq(d), 1);
}
static int gic_ack_fiq(struct irq_data *d)
@@ -430,7 +438,63 @@ static void __init gic_init_fiq(struct gic_chip_data *gic,
for (i = 0; i < num_irqs; i++)
fiq_register_mapping(first_irq + i, &gic_fiq);
}
+
+/*
+ * Fully acknowledge (both ack and eoi) a FIQ-based IPI
+ */
+static int gic_eoi_fiq_ipi(struct notifier_block *nb, unsigned long expected,
+ void *data)
+{
+ struct gic_chip_data *gic = &gic_data[0];
+ void __iomem *cpu_base = gic_data_cpu_base(gic);
+ unsigned long irqstat, irqnr, last_irqnr;
+
+ if (WARN_ON(!in_nmi()))
+ return NOTIFY_BAD;
+
+ irqnr = -1;
+ do {
+ irqstat = readl_relaxed(cpu_base + GIC_CPU_INTACK);
+ writel_relaxed(irqstat, cpu_base + GIC_CPU_EOI);
+
+ last_irqnr = irqnr;
+ irqnr = irqstat & GICC_IAR_INT_ID_MASK;
+ if (likely(irqnr == expected))
+ return NOTIFY_OK;
+
+ /* We're in pretty serious trouble if we get here. We cannot
+ * safely call the handler for the unexpected interrupt either
+ * because we don't know how (if it is a FIQ) or we can't do so
+ * safely (if it is an IRQ). The only recovery possible is to
+ * spuriously EOI (which we've already done by this point) and
+ * hope this is sufficient to clear the spurious FIQ.
+ */
+ WARN_RATELIMIT(1, "Unexpected irqnr %lu (expected %lu)\n",
+ irqnr, expected);
+ } while (last_irqnr != irqnr);
+
+ /* We've become stuck EOIing the same interrupt. There's nothing
+ * more we can do here except hope that "something has changed" and
+ * that the FIQ handler doesn't re-enter.
+ *
+ * We ratelimit the message because expecting something to change
+ * is really quite optimistic.
+ */
+ pr_crit_ratelimited("gic_eoi_fiq_ipi: Stuck on %lu, giving up\n",
+ irqnr);
+ return NOTIFY_BAD;
+}
+
+/*
+ * Notifier to ensure IPI FIQ is acknowledged correctly.
+ */
+static struct notifier_block gic_fiq_ipi_notifier = {
+ .notifier_call = gic_eoi_fiq_ipi,
+ .priority = 100,
+};
#else /* CONFIG_FIQ */
+static inline void gic_set_group_irq(void __iomem *base, unsigned int hwirq,
+ int group) {}
static inline void gic_init_fiq(struct gic_chip_data *gic,
irq_hw_number_t first_irq,
unsigned int num_irqs) {}
@@ -508,6 +572,7 @@ static void gic_cpu_init(struct gic_chip_data *gic)
void __iomem *base = gic_data_cpu_base(gic);
unsigned int cpu_mask, cpu = smp_processor_id();
int i;
+ u32 val;
/*
* Get what the GIC says our CPU mask is.
@@ -527,14 +592,19 @@ static void gic_cpu_init(struct gic_chip_data *gic)
gic_cpu_config(dist_base, NULL);
/*
- * Set all PPI and SGI interrupts to be group 1.
- *
- * If grouping is not available (not implemented or prohibited by
- * security mode) these registers are read-as-zero/write-ignored.
+ * Optionally set all PPI and SGI interrupts to be group 1.
*/
if (gic_data_fiq_enable(gic))
writel_relaxed(0xffffffff, dist_base + GIC_DIST_IGROUP + 0);
+ /*
+ * Optionally shift the FIQ based IPIs to group 0.
+ */
+ if (gic_data_fiq_enable(gic))
+ for (i = 0; i < 16; i++)
+ if (SMP_IPI_FIQ_MASK & (1 << i))
+ gic_set_group_irq(dist_base, i, 0);
+
writel_relaxed(0xf0, base + GIC_CPU_PRIMASK);
if (gic_data_fiq_enable(gic))
writel_relaxed(0x1f, base + GIC_CPU_CTRL);
@@ -747,7 +817,17 @@ static void gic_raise_softirq(const struct cpumask *mask, unsigned int irq)
unsigned long flags, map = 0;
unsigned long softint;
- raw_spin_lock_irqsave(&irq_controller_lock, flags);
+ /*
+ * The locking in this function ensures we don't use stale cpu mappings
+ * and thus we never route an IPI to the wrong physical core during a
+ * big.LITTLE switch. The switch code takes both of these locks meaning
+ * we can choose whichever lock is safe to use from our current calling
+ * context.
+ */
+ if (in_nmi())
+ raw_spin_lock(&fiq_safe_migration_lock);
+ else
+ raw_spin_lock_irqsave(&irq_controller_lock, flags);
/* Convert our logical CPU mask into a physical one. */
for_each_cpu(cpu, mask)
@@ -761,12 +841,16 @@ static void gic_raise_softirq(const struct cpumask *mask, unsigned int irq)
/* this always happens on GIC0 */
softint = map << 16 | irq;
- if (gic_data_fiq_enable(&gic_data[0]))
+ if (gic_data_fiq_enable(&gic_data[0]) &&
+ !(SMP_IPI_FIQ_MASK & (1 << irq)))
softint |= 0x8000;
writel_relaxed(softint,
gic_data_dist_base(&gic_data[0]) + GIC_DIST_SOFTINT);
- raw_spin_unlock_irqrestore(&irq_controller_lock, flags);
+ if (in_nmi())
+ raw_spin_unlock(&fiq_safe_migration_lock);
+ else
+ raw_spin_unlock_irqrestore(&irq_controller_lock, flags);
}
#endif
@@ -814,7 +898,7 @@ int gic_get_cpu_id(unsigned int cpu)
* Migrate all peripheral interrupts with a target matching the current CPU
* to the interface corresponding to @new_cpu_id. The CPU interface mapping
* is also updated. Targets to other CPU interfaces are unchanged.
- * This must be called with IRQs locally disabled.
+ * This must be called with IRQ and FIQ locally disabled.
*/
void gic_migrate_target(unsigned int new_cpu_id)
{
@@ -836,6 +920,7 @@ void gic_migrate_target(unsigned int new_cpu_id)
ror_val = (cur_cpu_id - new_cpu_id) & 31;
raw_spin_lock(&irq_controller_lock);
+ raw_spin_lock(&fiq_safe_migration_lock);
/* Update the target interface for this logical CPU */
gic_cpu_map[cpu] = 1 << new_cpu_id;
@@ -855,6 +940,7 @@ void gic_migrate_target(unsigned int new_cpu_id)
}
}
+ raw_spin_unlock(&fiq_safe_migration_lock);
raw_spin_unlock(&irq_controller_lock);
/*
@@ -1125,6 +1211,8 @@ void __init gic_init_bases(unsigned int gic_nr, int irq_start,
#ifdef CONFIG_SMP
set_smp_cross_call(gic_raise_softirq);
register_cpu_notifier(&gic_cpu_notifier);
+ if (gic_data_fiq_enable(gic))
+ register_fiq_ipi_notifier(&gic_fiq_ipi_notifier);
#endif
set_handle_irq(gic_handle_irq);
}
To support IPI FIQ we alter gic_cpu_init() to honour SMP_IPI_FIQ_MASK and register a fairly high priority notifier to acknowledge and clear the IPI when it is triggered. For the IPI FIQ to be useful we must also make it safe to call gic_raise_softirq() from the FIQ handler by altering the locking strategy slightly. Signed-off-by: Daniel Thompson <daniel.thompson@linaro.org> --- drivers/irqchip/irq-gic.c | 126 +++++++++++++++++++++++++++++++++++++++------- 1 file changed, 107 insertions(+), 19 deletions(-)