[v5,4/5] usb: host: ohci-st: Add ohci-st devicetree bindings documentation

Commit Message

Peter Griffin Aug. 15, 2014, 2:03 p.m. UTC

This patch documents the device tree bindings required for
the ohci on-chip controller found in ST consumer electronics SoC's.

Signed-off-by: Peter Griffin <[e-mail]>
---
 Documentation/devicetree/bindings/usb/ohci-st.txt | 37 +++++++++++++++++++++++
 1 file changed, 37 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/usb/ohci-st.txt

Patch

diff --git a/Documentation/devicetree/bindings/usb/ohci-st.txt b/Documentation/devicetree/bindings/usb/ohci-st.txt
new file mode 100644
index 0000000..6d83937
--- /dev/null
+++ b/Documentation/devicetree/bindings/usb/ohci-st.txt
@@ -0,0 +1,37 @@ 
+ST USB OHCI controller
+
+Required properties:
+
+ - compatible		: must be "st,st-ohci-300x"
+ - reg			: physical base addresses of the controller and length of memory mapped
+			  region
+ - interrupts		: one OHCI controller interrupt should be described here
+ - clocks		: phandle list of usb clocks
+ - clock-names		: should be "ic" for interconnect clock and "clk48"
+See: Documentation/devicetree/bindings/clock/clock-bindings.txt
+
+ - phys			: phandle for the PHY device
+ - phy-names		: should be "usb"
+
+ - resets		: phandle to the powerdown and reset controller for the USB IP
+ - reset-names		: should be "power" and "softreset".
+See: Documentation/devicetree/bindings/reset/st,sti-powerdown.txt
+See: Documentation/devicetree/bindings/reset/reset.txt
+
+Example:
+
+	ohci0: usb@0xfe1ffc00 {
+		compatible = "st,st-ohci-300x";
+		reg = <0xfe1ffc00 0x100>;
+		interrupts = <GIC_SPI 149 IRQ_TYPE_NONE>;
+		clocks = <&clk_s_a1_ls 0>,
+			 <&clockgen_b0 0>;
+		clock-names = "ic", "clk48";
+		phys = <&usb2_phy>;
+		phy-names = "usb";
+		status = "okay";
+
+		resets = <&powerdown STIH416_USB0_POWERDOWN>,
+			 <&softreset STIH416_USB0_SOFTRESET>;
+		reset-names = "power", "softreset";
+	};