@@ -85,6 +85,75 @@
gpios = <&gpio LPC_GPIO(4,13) GPIO_ACTIVE_LOW>;
};
};
+
+ leds_mmio {
+ compatible = "gpio-leds";
+
+ led1 {
+ gpios = <&mmio_leds 15 GPIO_ACTIVE_HIGH>;
+ linux,default-trigger = "heartbeat";
+ };
+
+ led2 {
+ gpios = <&mmio_leds 14 GPIO_ACTIVE_HIGH>;
+ };
+
+ led3 {
+ gpios = <&mmio_leds 13 GPIO_ACTIVE_HIGH>;
+ };
+
+ led4 {
+ gpios = <&mmio_leds 12 GPIO_ACTIVE_HIGH>;
+ };
+
+ led5 {
+ gpios = <&mmio_leds 11 GPIO_ACTIVE_HIGH>;
+ };
+
+ led6 {
+ gpios = <&mmio_leds 10 GPIO_ACTIVE_HIGH>;
+ };
+
+ led7 {
+ gpios = <&mmio_leds 9 GPIO_ACTIVE_HIGH>;
+ };
+
+ led8 {
+ gpios = <&mmio_leds 8 GPIO_ACTIVE_HIGH>;
+ };
+
+ led9 {
+ gpios = <&mmio_leds 7 GPIO_ACTIVE_HIGH>;
+ };
+
+ led10 {
+ gpios = <&mmio_leds 6 GPIO_ACTIVE_HIGH>;
+ };
+
+ led11 {
+ gpios = <&mmio_leds 5 GPIO_ACTIVE_HIGH>;
+ };
+
+ led12 {
+ gpios = <&mmio_leds 4 GPIO_ACTIVE_HIGH>;
+ };
+
+ led13 {
+ gpios = <&mmio_leds 3 GPIO_ACTIVE_HIGH>;
+ };
+
+ led14 {
+ gpios = <&mmio_leds 2 GPIO_ACTIVE_HIGH>;
+ };
+
+ led15 {
+ gpios = <&mmio_leds 1 GPIO_ACTIVE_HIGH>;
+ };
+
+ led16 {
+ gpios = <&mmio_leds 0 GPIO_ACTIVE_HIGH>;
+ };
+ };
};
&pinctrl {
Hook up LEDs on the outputs from the D-type flip-flop found on the address/data bus. Note that the LEDx label in the schematics is reversed in regard to the bits on the data bus. Hence the reverse ordering used here. Signed-off-by: Joachim Eastwood <manabian@gmail.com> --- arch/arm/boot/dts/lpc4357-ea4357-devkit.dts | 69 +++++++++++++++++++++++++++++ 1 file changed, 69 insertions(+)