diff mbox

ARM: BCM5301X: Netgear R6250 add USB GPIO

Message ID 1442661954-27951-1-git-send-email-hauke@hauke-m.de (mailing list archive)
State New, archived
Headers show

Commit Message

Hauke Mehrtens Sept. 19, 2015, 11:25 a.m. UTC 
Add GPIO number which is needed to activate the USB power supply.

Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
---
 arch/arm/boot/dts/bcm4708-netgear-r6250.dts | 11 +++++++++++
 1 file changed, 11 insertions(+)

Comments

Florian Fainelli Sept. 21, 2015, 5:37 p.m. UTC | #1 
On 19/09/15 04:25, Hauke Mehrtens wrote:
> Add GPIO number which is needed to activate the USB power supply.
> 
> Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>

Applied to devicetree/next, thanks!
diff mbox

Patch

diff --git a/arch/arm/boot/dts/bcm4708-netgear-r6250.dts b/arch/arm/boot/dts/bcm4708-netgear-r6250.dts
index 64b8d10..ca92bba 100644
--- a/arch/arm/boot/dts/bcm4708-netgear-r6250.dts
+++ b/arch/arm/boot/dts/bcm4708-netgear-r6250.dts
@@ -24,6 +24,17 @@ 
 		reg = <0x00000000 0x08000000>;
 	};
 
+	axi@18000000 {
+		usb3@23000 {
+			reg = <0x00023000 0x1000>;
+
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			vcc-gpio = <&chipcommon 0 GPIO_ACTIVE_HIGH>;
+		};
+	};
+
 	leds {
 		compatible = "gpio-leds";