| Message ID | 1448706409-16912-1-git-send-email-sebastian.hesselbarth@gmail.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
On Sat, Nov 28, 2015 at 11:26 AM, Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com> wrote: > Common MVEBU pinctrl driver core gets an array of controls to modify > a specific set of registers and an array of modes for each pingroup > from each of the different SoC families of MVEBU. > > Some SoC families comprise different variants that differ in available > pingroups and also controls, but to ease driver development, we can > pass a variant mask to disable specific pingroups for some variants. > However, controls are limited to the true number of pinctrl groups > avaiable on a variant. > > Now, when pinctrl core driver parses over above arrays, it tries to > match modes with available controls and complains about missing > controls for modes that are passed to the core but actually are not > avaiable on a variant with: > > kirkwood-pinctrl f1010000.pin-controller: unknown pinctrl group 36 > > This warning is a false-positive and annoying, so move the warning > after we checked the variant mask for each mode setting. Also, if > there is no supported setting for this variant, do not complain at > all. > > Signed-off-by: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com> > Reported-by: Linus Walleij <linus.walleij@linaro.org> > --- > Changelog: > v1->v2: > - modify settings loop to allow to check for !num_settings Patch applied! Yours, Linus Walleij
diff --git a/drivers/pinctrl/mvebu/pinctrl-mvebu.c b/drivers/pinctrl/mvebu/pinctrl-mvebu.c index 77d2221d379d..e4d473811bb3 100644 --- a/drivers/pinctrl/mvebu/pinctrl-mvebu.c +++ b/drivers/pinctrl/mvebu/pinctrl-mvebu.c @@ -663,28 +663,20 @@ int mvebu_pinctrl_probe(struct platform_device *pdev) /* assign mpp modes to groups */ for (n = 0; n < soc->nmodes; n++) { struct mvebu_mpp_mode *mode = &soc->modes[n]; - struct mvebu_pinctrl_group *grp = - mvebu_pinctrl_find_group_by_pid(pctl, mode->pid); + struct mvebu_mpp_ctrl_setting *set = &mode->settings[0]; + struct mvebu_pinctrl_group *grp; unsigned num_settings; - if (!grp) { - dev_warn(&pdev->dev, "unknown pinctrl group %d\n", - mode->pid); - continue; - } - - for (num_settings = 0; ;) { - struct mvebu_mpp_ctrl_setting *set = - &mode->settings[num_settings]; - + for (num_settings = 0; ; set++) { if (!set->name) break; - num_settings++; /* skip unsupported settings for this variant */ if (pctl->variant && !(pctl->variant & set->variant)) continue; + num_settings++; + /* find gpio/gpo/gpi settings */ if (strcmp(set->name, "gpio") == 0) set->flags = MVEBU_SETTING_GPI | @@ -695,6 +687,17 @@ int mvebu_pinctrl_probe(struct platform_device *pdev) set->flags = MVEBU_SETTING_GPI; } + /* skip modes with no settings for this variant */ + if (!num_settings) + continue; + + grp = mvebu_pinctrl_find_group_by_pid(pctl, mode->pid); + if (!grp) { + dev_warn(&pdev->dev, "unknown pinctrl group %d\n", + mode->pid); + continue; + } + grp->settings = mode->settings; grp->num_settings = num_settings; }
Common MVEBU pinctrl driver core gets an array of controls to modify a specific set of registers and an array of modes for each pingroup from each of the different SoC families of MVEBU. Some SoC families comprise different variants that differ in available pingroups and also controls, but to ease driver development, we can pass a variant mask to disable specific pingroups for some variants. However, controls are limited to the true number of pinctrl groups avaiable on a variant. Now, when pinctrl core driver parses over above arrays, it tries to match modes with available controls and complains about missing controls for modes that are passed to the core but actually are not avaiable on a variant with: kirkwood-pinctrl f1010000.pin-controller: unknown pinctrl group 36 This warning is a false-positive and annoying, so move the warning after we checked the variant mask for each mode setting. Also, if there is no supported setting for this variant, do not complain at all. Signed-off-by: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com> Reported-by: Linus Walleij <linus.walleij@linaro.org> --- Changelog: v1->v2: - modify settings loop to allow to check for !num_settings Cc: Linus Walleij <linus.walleij@linaro.org> Cc: Simon Guinot <simon.guinot@sequanux.org> Cc: Thomas Petazzoni <thomas.petazzoni@free-electrons.com> Cc: Jason Cooper <jason@lakedaemon.net> Cc: Andrew Lunn <andrew@lunn.ch> Cc: Gregory Clement <gregory.clement@free-electrons.com> Cc: linux-gpio@vger.kernel.org Cc: linux-arm-kernel@lists.infradead.org Cc: linux-kernel@vger.kernel.org --- drivers/pinctrl/mvebu/pinctrl-mvebu.c | 29 ++++++++++++++++------------- 1 file changed, 16 insertions(+), 13 deletions(-)