[v3,2/3] ARM: dts: vf-colibri: add basic supply regulators

Commit Message

Stefan Agner Feb. 17, 2016, 11:40 p.m. UTC

Colibri modules need to be powered using the power pins 3V3 and
AVDD_AUDIO. Add fixed regulators which represent this power rails.
Potentially, those power rails could be switched on a carrier
board. A carrier board device tree could add a own regulator with
a GPIO, and reference that regulator in a vin-supply property of
those new module level system regulators.

Signed-off-by: Stefan Agner <[e-mail]>
---
Changes since v2:
- remove regulator-always-on

Changes since v1:
- Add module prefix to avoid namespace issue with Carrier Board regulators
- Name the regulators according to schematics

 arch/arm/boot/dts/vf-colibri.dtsi | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

Patch

diff --git a/arch/arm/boot/dts/vf-colibri.dtsi b/arch/arm/boot/dts/vf-colibri.dtsi
index ff6f58e..ed4cfc5 100644
--- a/arch/arm/boot/dts/vf-colibri.dtsi
+++ b/arch/arm/boot/dts/vf-colibri.dtsi
@@ -48,14 +48,30 @@ 
 		enable-gpios = <&gpio1 13 GPIO_ACTIVE_HIGH>;
 		status = "disabled";
 	};
+
+	reg_module_3v3: regulator-module-3v3 {
+		compatible = "regulator-fixed";
+		regulator-name = "+V3.3";
+		regulator-min-microvolt = <3300000>;
+		regulator-max-microvolt = <3300000>;
+	};
+
+	reg_module_3v3_avdd: regulator-module-3v3-avdd {
+		compatible = "regulator-fixed";
+		regulator-name = "+V3.3_AVDD_AUDIO";
+		regulator-min-microvolt = <3300000>;
+		regulator-max-microvolt = <3300000>;
+	};
 };
 
 &adc0 {
 	status = "okay";
+	vref-supply = <&reg_module_3v3_avdd>;
 };
 
 &adc1 {
 	status = "okay";
+	vref-supply = <&reg_module_3v3_avdd>;
 };
 
 &can0 {
@@ -96,6 +112,7 @@ 
 
 &fec1 {
 	phy-mode = "rmii";
+	phy-supply = <&reg_module_3v3>;
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_fec1>;
 };