| Message ID | 1466640035-29139-1-git-send-email-f.fainelli@gmail.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
On Wed, Jun 22, 2016 at 8:00 PM, Florian Fainelli <f.fainelli@gmail.com> wrote: > Add support for the Broadcom BCM953012 Enterprise Router reference > board, enable the following peripherals: > > - UART0 (UART1 is not populated) > - WPS and restart GPIO buttons > - Ethernet switch w/ only two facing ports > - NAND flash > - SPI-NOR flash > > Signed-off-by: Florian Fainelli <f.fainelli@gmail.com> Acked-by: Jon Mason <jon.mason@broadcom.com> > --- > arch/arm/boot/dts/Makefile | 1 + > arch/arm/boot/dts/bcm953012er.dts | 104 ++++++++++++++++++++++++++++++++++++++ > 2 files changed, 105 insertions(+) > create mode 100644 arch/arm/boot/dts/bcm953012er.dts > > diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile > index 06b6c2d695bf..cbd13ea4b71e 100644 > --- a/arch/arm/boot/dts/Makefile > +++ b/arch/arm/boot/dts/Makefile > @@ -85,6 +85,7 @@ dtb-$(CONFIG_ARCH_BCM_5301X) += \ > bcm47094-dlink-dir-885l.dtb \ > bcm94708.dtb \ > bcm94709.dtb \ > + bcm953012er.dtb \ > bcm953012k.dtb > dtb-$(CONFIG_ARCH_BCM_63XX) += \ > bcm963138dvt.dtb > diff --git a/arch/arm/boot/dts/bcm953012er.dts b/arch/arm/boot/dts/bcm953012er.dts > new file mode 100644 > index 000000000000..0a9abecf9423 > --- /dev/null > +++ b/arch/arm/boot/dts/bcm953012er.dts > @@ -0,0 +1,104 @@ > +/* > + * BSD LICENSE > + * > + * Copyright(c) 2016 Broadcom. All rights reserved. > + * > + * Redistribution and use in source and binary forms, with or without > + * modification, are permitted provided that the following conditions > + * are met: > + * > + * * Redistributions of source code must retain the above copyright > + * notice, this list of conditions and the following disclaimer. > + * * Redistributions in binary form must reproduce the above copyright > + * notice, this list of conditions and the following disclaimer in > + * the documentation and/or other materials provided with the > + * distribution. > + * * Neither the name of Broadcom Corporation nor the names of its > + * contributors may be used to endorse or promote products derived > + * from this software without specific prior written permission. > + * > + * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS > + * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT > + * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR > + * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT > + * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, > + * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT > + * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, > + * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY > + * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT > + * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE > + * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. > + */ > + > +/dts-v1/; > + > +#include "bcm4708.dtsi" > +#include "bcm5301x-nand-cs0-bch8.dtsi" > + > +/ { > + model = "NorthStar Enterprise Router (BCM953012ER)"; > + compatible = "brcm,bcm953012er", "brcm,brcm53012", "brcm,bcm4708"; > + > + aliases { > + serial0 = &uart0; > + }; > + > + chosen { > + stdout-path = "serial0:115200n8"; > + }; > + > + memory { > + reg = <0x00000000 0x8000000>; > + }; > + > + gpio-keys { > + compatible = "gpio-keys"; > + #address-cells = <1>; > + #size-cells = <0>; > + > + wps { > + label = "WPS"; > + linux,code = <KEY_WPS_BUTTON>; > + gpios = <&chipcommon 6 GPIO_ACTIVE_LOW>; > + }; > + > + restart { > + label = "Reset"; > + linux,code = <KEY_RESTART>; > + gpios = <&chipcommon 15 GPIO_ACTIVE_LOW>; > + }; > + }; > +}; > + > +&uart0 { > + status = "okay"; > +}; > + > +&spi_nor { > + status = "okay"; > +}; > + > +&srab { > + status = "okay"; > + > + ports { > + #address-cells = <1>; > + #size-cells = <0>; > + > + port@0 { > + reg = <0>; > + label = "port0"; > + }; > + > + port@1 { > + reg = <1>; > + label = "port1"; > + }; > + > + port@5 { > + reg = <5>; > + label = "cpu"; > + ethernet = <&gmac0>; > + }; > + }; > +}; > -- > 2.7.4 >
On 06/28/2016 11:18 AM, Jon Mason wrote: > On Wed, Jun 22, 2016 at 8:00 PM, Florian Fainelli <f.fainelli@gmail.com> wrote: >> Add support for the Broadcom BCM953012 Enterprise Router reference >> board, enable the following peripherals: >> >> - UART0 (UART1 is not populated) >> - WPS and restart GPIO buttons >> - Ethernet switch w/ only two facing ports >> - NAND flash >> - SPI-NOR flash >> >> Signed-off-by: Florian Fainelli <f.fainelli@gmail.com> > Acked-by: Jon Mason <jon.mason@broadcom.com> Applied, thanks!
diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile index 06b6c2d695bf..cbd13ea4b71e 100644 --- a/arch/arm/boot/dts/Makefile +++ b/arch/arm/boot/dts/Makefile @@ -85,6 +85,7 @@ dtb-$(CONFIG_ARCH_BCM_5301X) += \ bcm47094-dlink-dir-885l.dtb \ bcm94708.dtb \ bcm94709.dtb \ + bcm953012er.dtb \ bcm953012k.dtb dtb-$(CONFIG_ARCH_BCM_63XX) += \ bcm963138dvt.dtb diff --git a/arch/arm/boot/dts/bcm953012er.dts b/arch/arm/boot/dts/bcm953012er.dts new file mode 100644 index 000000000000..0a9abecf9423 --- /dev/null +++ b/arch/arm/boot/dts/bcm953012er.dts @@ -0,0 +1,104 @@ +/* + * BSD LICENSE + * + * Copyright(c) 2016 Broadcom. All rights reserved. + * + * Redistribution and use in source and binary forms, with or without + * modification, are permitted provided that the following conditions + * are met: + * + * * Redistributions of source code must retain the above copyright + * notice, this list of conditions and the following disclaimer. + * * Redistributions in binary form must reproduce the above copyright + * notice, this list of conditions and the following disclaimer in + * the documentation and/or other materials provided with the + * distribution. + * * Neither the name of Broadcom Corporation nor the names of its + * contributors may be used to endorse or promote products derived + * from this software without specific prior written permission. + * + * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS + * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT + * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR + * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT + * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, + * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT + * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, + * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY + * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT + * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE + * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. + */ + +/dts-v1/; + +#include "bcm4708.dtsi" +#include "bcm5301x-nand-cs0-bch8.dtsi" + +/ { + model = "NorthStar Enterprise Router (BCM953012ER)"; + compatible = "brcm,bcm953012er", "brcm,brcm53012", "brcm,bcm4708"; + + aliases { + serial0 = &uart0; + }; + + chosen { + stdout-path = "serial0:115200n8"; + }; + + memory { + reg = <0x00000000 0x8000000>; + }; + + gpio-keys { + compatible = "gpio-keys"; + #address-cells = <1>; + #size-cells = <0>; + + wps { + label = "WPS"; + linux,code = <KEY_WPS_BUTTON>; + gpios = <&chipcommon 6 GPIO_ACTIVE_LOW>; + }; + + restart { + label = "Reset"; + linux,code = <KEY_RESTART>; + gpios = <&chipcommon 15 GPIO_ACTIVE_LOW>; + }; + }; +}; + +&uart0 { + status = "okay"; +}; + +&spi_nor { + status = "okay"; +}; + +&srab { + status = "okay"; + + ports { + #address-cells = <1>; + #size-cells = <0>; + + port@0 { + reg = <0>; + label = "port0"; + }; + + port@1 { + reg = <1>; + label = "port1"; + }; + + port@5 { + reg = <5>; + label = "cpu"; + ethernet = <&gmac0>; + }; + }; +};