@@ -118,8 +118,6 @@ static irqreturn_t nop_gpio_vbus_thread(int irq, void *data)
status = USB_EVENT_VBUS;
otg->state = OTG_STATE_B_PERIPHERAL;
nop->phy.last_event = status;
- if (otg->gadget)
- usb_gadget_vbus_connect(otg->gadget);
/* drawing a "unit load" is *always* OK, except for OTG */
nop_set_vbus_draw(nop, 100);
@@ -129,8 +127,6 @@ static irqreturn_t nop_gpio_vbus_thread(int irq, void *data)
} else {
nop_set_vbus_draw(nop, 0);
- if (otg->gadget)
- usb_gadget_vbus_disconnect(otg->gadget);
status = USB_EVENT_NONE;
otg->state = OTG_STATE_B_IDLE;
nop->phy.last_event = status;
@@ -187,7 +183,8 @@ static int nop_set_peripheral(struct usb_otg *otg, struct usb_gadget *gadget)
otg->gadget = gadget;
if (otg->state == OTG_STATE_B_PERIPHERAL)
- usb_gadget_vbus_connect(gadget);
+ atomic_notifier_call_chain(&otg->usb_phy->notifier,
+ USB_EVENT_VBUS, otg->gadget);
else
otg->state = OTG_STATE_B_IDLE;
return 0;
As the last known user, ie. pxa27x_udc relying on calls to usb_gadget_xxx() was amended to use the phy notifier, remove a bit the USB stack adherence. Actually the driver still uses the gadget API for structures definition, but the implementation of USB gadget specific function usb_gadget_*() is not necessary anymore. Signed-off-by: Robert Jarzmik <robert.jarzmik@free.fr> --- drivers/usb/phy/phy-generic.c | 7 ++----- 1 file changed, 2 insertions(+), 5 deletions(-)