@@ -302,11 +302,13 @@ static void fsmc_cmd_ctrl(struct mtd_info *mtd, int cmd, unsigned int ctrl)
* This routine initializes timing parameters related to NAND memory access in
* FSMC registers
*/
-static void fsmc_nand_setup(void __iomem *regs, uint32_t bank,
- uint32_t busw, struct fsmc_nand_timings *timings)
+static void fsmc_nand_setup(struct fsmc_nand_data *host,
+ struct fsmc_nand_timings *timings)
{
uint32_t value = FSMC_DEVTYPE_NAND | FSMC_ENABLE | FSMC_WAITON;
uint32_t tclr, tar, thiz, thold, twait, tset;
+ unsigned int bank = host->bank;
+ void __iomem *regs = host->regs_va;
struct fsmc_nand_timings *tims;
struct fsmc_nand_timings default_timings = {
.tclr = FSMC_TCLR_1,
@@ -318,7 +320,7 @@ static void fsmc_nand_setup(void __iomem *regs, uint32_t bank,
};
if (timings)
- tims = timings;
+ tims = host->dev_timings;
else
tims = &default_timings;
@@ -329,7 +331,7 @@ static void fsmc_nand_setup(void __iomem *regs, uint32_t bank,
twait = (tims->twait & FSMC_TWAIT_MASK) << FSMC_TWAIT_SHIFT;
tset = (tims->tset & FSMC_TSET_MASK) << FSMC_TSET_SHIFT;
- if (busw)
+ if (host->nand.options & NAND_BUSWIDTH_16)
writel_relaxed(value | FSMC_DEVWID_16,
FSMC_NAND_REG(regs, bank, PC));
else
@@ -933,9 +935,7 @@ static int __init fsmc_nand_probe(struct platform_device *pdev)
break;
}
- fsmc_nand_setup(host->regs_va, host->bank,
- nand->options & NAND_BUSWIDTH_16,
- host->dev_timings);
+ fsmc_nand_setup(host, host->dev_timings);
if (AMBA_REV_BITS(host->pid) >= 8) {
nand->ecc.read_page = fsmc_read_page_hwecc;
@@ -1073,9 +1073,7 @@ static int fsmc_nand_resume(struct device *dev)
struct fsmc_nand_data *host = dev_get_drvdata(dev);
if (host) {
clk_prepare_enable(host->clk);
- fsmc_nand_setup(host->regs_va, host->bank,
- host->nand.options & NAND_BUSWIDTH_16,
- host->dev_timings);
+ fsmc_nand_setup(host, host->dev_timings);
}
return 0;
}
In preparation for the introduction of support for using SDR timings exposed by the NAND flash instead of hard-coded timings, this commit reworks the fsmc_nand_setup() function to take a "struct fsmc_nand_data" as argument, which already contains the I/O registers base address, bank and bus width information. The timings is also currently contained in the "struct fsmc_nand_data", but we still pass it as a separate argument because the support for using SDR timings will pass a different value. Signed-off-by: Thomas Petazzoni <thomas.petazzoni@free-electrons.com> --- drivers/mtd/nand/fsmc_nand.c | 18 ++++++++---------- 1 file changed, 8 insertions(+), 10 deletions(-)