@@ -118,3 +118,59 @@ Example:
other nodes ...
};
+
+
+USB3 core reset
+---------------
+
+USB3 core reset belongs to USB3 glue layer. Before using the core reset,
+it is necessary to control the clocks and resets to enable this layer.
+These clocks and resets should be described in each property.
+
+Required properties:
+- compatible: Should be
+ "socionext,uniphier-pro4-usb3-reset" - for Pro4 SoC
+ "socionext,uniphier-pxs2-usb3-reset" - for PXs2 SoC
+ "socionext,uniphier-ld20-usb3-reset" - for LD20 SoC
+ "socionext,uniphier-pxs3-usb3-reset" - for PXs3 SoC
+- #reset-cells: Should be 1.
+- reg: Specifies offset and length of the register set for the device.
+- clocks: A list of phandles to the clock gate for USB3 glue layer.
+ According to the clock-names, appropriate clocks are required.
+- clock-names: Should contain
+ "gio", "link" - for Pro4 SoC
+ "link" - for others
+- resets: A list of phandles to the reset control for USB3 glue layer.
+ According to the reset-names, appropriate resets are required.
+- reset-names: Should contain
+ "gio", "link" - for Pro4 SoC
+ "link" - for others
+
+Example:
+
+ usb-glue@65b00000 {
+ compatible = "socionext,uniphier-ld20-dwc3-glue",
+ "simple-mfd";
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0 0x65b00000 0x400>;
+
+ usb_rst: reset@0 {
+ compatible = "socionext,uniphier-ld20-usb3-reset";
+ reg = <0x0 0x4>;
+ #reset-cells = <1>;
+ clock-names = "link";
+ clocks = <&sys_clk 14>;
+ reset-names = "link";
+ resets = <&sys_rst 14>;
+ };
+
+ regulator {
+ ...
+ };
+
+ phy {
+ ...
+ };
+ ...
+ };
Add DT bindings for reset control of USB3 core implemented in UniPhier SoCs. The reset control belongs to USB3 glue layer. Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@socionext.com> --- .../devicetree/bindings/reset/uniphier-reset.txt | 56 ++++++++++++++++++++++ 1 file changed, 56 insertions(+)