diff mbox series

[V2,5/6] mmc: mmci: stm32: define get_dctrl_cfg

Message ID 1551976742-4358-6-git-send-email-ludovic.Barre@st.com (mailing list archive)
State New, archived
Headers show
Series mmc: mmci: add get_datactrl_cfg callback | expand

Commit Message

Ludovic BARRE March 7, 2019, 4:39 p.m. UTC 
From: Ludovic Barre <ludovic.barre@st.com>

This patch defines get_dctrl_cfg callback for sdmmc variant.
sdmmc variant has specific stm32 transfer modes.
sdmmc data transfer mode selection could be:
-Block data transfer ending on block count.
-SDIO multibyte data transfer.
-MMC Stream data transfer (not used).
-Block data transfer ending with STOP_TRANSMISSION command.

Signed-off-by: Ludovic Barre <ludovic.barre@st.com>
---
 drivers/mmc/host/mmci.h             |  5 +++++
 drivers/mmc/host/mmci_stm32_sdmmc.c | 19 +++++++++++++++++++
 2 files changed, 24 insertions(+)
diff mbox series

Patch

diff --git a/drivers/mmc/host/mmci.h b/drivers/mmc/host/mmci.h
index bfc6e54..4d33c4f 100644
--- a/drivers/mmc/host/mmci.h
+++ b/drivers/mmc/host/mmci.h
@@ -131,6 +131,11 @@ 
 /* Control register extensions in the Qualcomm versions */
 #define MCI_DPSM_QCOM_DATA_PEND	BIT(17)
 #define MCI_DPSM_QCOM_RX_DATA_PEND BIT(20)
+/* Control register extensions in STM32 versions */
+#define MCI_DPSM_STM32_MODE_BLOCK	(0 << 2)
+#define MCI_DPSM_STM32_MODE_SDIO	(1 << 2)
+#define MCI_DPSM_STM32_MODE_STREAM	(2 << 2)
+#define MCI_DPSM_STM32_MODE_BLOCK_STOP	(3 << 2)
 
 #define MMCIDATACNT		0x030
 #define MMCISTATUS		0x034
diff --git a/drivers/mmc/host/mmci_stm32_sdmmc.c b/drivers/mmc/host/mmci_stm32_sdmmc.c
index cfbfc6f..4c710e1 100644
--- a/drivers/mmc/host/mmci_stm32_sdmmc.c
+++ b/drivers/mmc/host/mmci_stm32_sdmmc.c
@@ -265,10 +265,29 @@  static void mmci_sdmmc_set_pwrreg(struct mmci_host *host, unsigned int pwr)
 	}
 }
 
+static u32 sdmmc_get_dctrl_cfg(struct mmci_host *host)
+{
+	u32 datactrl;
+
+	datactrl = mmci_dctrl_blksz(host) | mmci_dctrl_dir(host);
+	datactrl |= mmci_dctrl_sdio(host) | mmci_dctrl_ddr(host);
+
+	if (host->mmc->card && mmc_card_sdio(host->mmc->card) &&
+	    host->data->blocks == 1)
+		datactrl |= MCI_DPSM_STM32_MODE_SDIO;
+	else if (host->data->stop && !host->mrq->sbc)
+		datactrl |= MCI_DPSM_STM32_MODE_BLOCK_STOP;
+	else
+		datactrl |= MCI_DPSM_STM32_MODE_BLOCK;
+
+	return datactrl;
+}
+
 static struct mmci_host_ops sdmmc_variant_ops = {
 	.validate_data = sdmmc_idma_validate_data,
 	.prep_data = sdmmc_idma_prep_data,
 	.unprep_data = sdmmc_idma_unprep_data,
+	.get_datactrl_cfg = sdmmc_get_dctrl_cfg,
 	.dma_setup = sdmmc_idma_setup,
 	.dma_start = sdmmc_idma_start,
 	.dma_finalize = sdmmc_idma_finalize,