| Message ID | 1601269303-12167-1-git-send-email-Anson.Huang@nxp.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | thermal: imx: Correct run_measurement check method | expand |
diff --git a/drivers/thermal/imx_thermal.c b/drivers/thermal/imx_thermal.c index 2c7473d..9f00182 100644 --- a/drivers/thermal/imx_thermal.c +++ b/drivers/thermal/imx_thermal.c @@ -255,7 +255,8 @@ static int imx_get_temp(struct thermal_zone_device *tz, int *temp) bool wait, run_measurement; u32 val; - run_measurement = !data->irq_enabled; + regmap_read(map, soc_data->sensor_ctrl, &val); + run_measurement = val & soc_data->power_down_mask; if (!run_measurement) { /* Check if a measurement is currently in progress */ regmap_read(map, soc_data->temp_data, &val);
It is incorrect to use irq_enabled flag for run_measurement check, as irq_enabled is NOT always equal to thermal mode, when temperature is higher than passive point, an alarm irq will be pending, and irq_enabled flag will be set to false while thermal mode is still enabled, then the following temperature read will power down thermal sensor, and next time irq_enabled flag will set to true when temperature drop to below than passive point, next temperature read will fail due to thermal sensor is NOT power up at all, the error log is as below: root@imx6qdlsolo:~# cat /sys/class/thermal/thermal_zone0/temp cat: /sys/class/thermal/thermal_zone0/temp: Resource temporarily unavailable So, it should read the thermal sensor's power down bit to decide whether to run measurement. Fixes: d92ed2c9d3ff ("thermal: imx: Use driver's local data to decide whether to run a measurement") Signed-off-by: Anson Huang <Anson.Huang@nxp.com> --- drivers/thermal/imx_thermal.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)