@@ -1,9 +1,11 @@
-* Real Time Clock of the Armada 38x SoCs
+* Real Time Clock of the Armada 38x/7K/8K SoCs
-RTC controller for the Armada 38x SoCs
+RTC controller for the Armada 38x, 7K and 8K SoCs
Required properties:
-- compatible : Should be "marvell,armada-380-rtc"
+- compatible : Should be one of the following:
+ "marvell,armada-380-rtc" for Armada 38x SoC
+ "marvell,armada-8k-rtc" for Aramda 7K/8K SoCs
- reg: a list of base address and size pairs, one for each entry in
reg-names
- reg names: should contain:
@@ -24,18 +24,36 @@
#define RTC_STATUS_ALARM1 BIT(0)
#define RTC_STATUS_ALARM2 BIT(1)
#define RTC_IRQ1_CONF 0x4
+#define RTC_IRQ2_CONF 0x8
#define RTC_IRQ_AL_EN BIT(0)
#define RTC_IRQ_FREQ_EN BIT(1)
#define RTC_IRQ_FREQ_1HZ BIT(2)
#define RTC_TIME 0xC
#define RTC_ALARM1 0x10
+#define RTC_ALARM2 0x14
+
+/* Armada38x SoC registers */
#define RTC_38X_BRIDGE_TIMING_CTL 0x0
#define RTC_38X_PERIOD_OFFS 0
#define RTC_38X_PERIOD_MASK (0x3FF << RTC_38X_PERIOD_OFFS)
#define RTC_38X_READ_DELAY_OFFS 26
#define RTC_38X_READ_DELAY_MASK (0x1F << RTC_38X_READ_DELAY_OFFS)
+/* Armada 7K/8K registers */
+#define RTC_8K_BRIDGE_TIMING_CTL0 0x0
+#define RTC_8K_WRCLK_PERIOD_OFFS 0
+#define RTC_8K_WRCLK_PERIOD_MASK (0xFFFF << RTC_8K_WRCLK_PERIOD_OFFS)
+#define RTC_8K_WRCLK_SETUP_OFFS 16
+#define RTC_8K_WRCLK_SETUP_MASK (0xFFFF << RTC_8K_WRCLK_SETUP_OFFS)
+#define RTC_8K_BRIDGE_TIMING_CTL1 0x4
+#define RTC_8K_READ_DELAY_OFFS 0
+#define RTC_8K_READ_DELAY_MASK (0xFFFF << RTC_8K_READ_DELAY_OFFS)
+
+#define RTC_8K_ISR 0x10
+#define RTC_8K_IMR 0x14
+#define RTC_8K_ALARM2 BIT(0)
+
#define SOC_RTC_INTERRUPT 0x8
#define SOC_RTC_ALARM1 BIT(0)
#define SOC_RTC_ALARM2 BIT(1)
@@ -60,6 +78,8 @@ struct armada38x_rtc {
};
#define ALARM1 0
+#define ALARM2 1
+
#define ALARM_REG(base, alarm) ((base) + (alarm) * sizeof(u32))
struct armada38x_rtc_data {
@@ -102,6 +122,28 @@ static void rtc_update_38x_mbus_timing_params(struct armada38x_rtc *rtc)
writel(reg, rtc->regs_soc + RTC_38X_BRIDGE_TIMING_CTL);
}
+static void rtc_update_8k_mbus_timing_params(struct armada38x_rtc *rtc)
+{
+ u32 reg;
+
+ reg = readl(rtc->regs_soc + RTC_8K_BRIDGE_TIMING_CTL0);
+ reg &= ~RTC_8K_WRCLK_PERIOD_MASK;
+ reg |= 0x3FF << RTC_8K_WRCLK_PERIOD_OFFS;
+ reg &= ~RTC_8K_WRCLK_SETUP_MASK;
+ reg |= 0x29 << RTC_8K_WRCLK_SETUP_OFFS;
+ writel(reg, rtc->regs_soc + RTC_8K_BRIDGE_TIMING_CTL0);
+
+ reg = readl(rtc->regs_soc + RTC_8K_BRIDGE_TIMING_CTL1);
+ reg &= ~RTC_8K_READ_DELAY_MASK;
+ reg |= 0x3F << RTC_8K_READ_DELAY_OFFS;
+ writel(reg, rtc->regs_soc + RTC_8K_BRIDGE_TIMING_CTL1);
+}
+
+static u32 read_rtc_register(struct armada38x_rtc *rtc, u8 rtc_reg)
+{
+ return readl(rtc->regs + rtc_reg);
+}
+
static u32 read_rtc_register_38x_wa(struct armada38x_rtc *rtc, u8 rtc_reg)
{
int i, index_max = 0, max = 0;
@@ -157,6 +199,17 @@ static void armada38x_unmask_interrupt(struct armada38x_rtc *rtc)
writel(val | SOC_RTC_ALARM1_MASK, rtc->regs_soc + SOC_RTC_INTERRUPT);
}
+
+static void armada8k_clear_isr(struct armada38x_rtc *rtc)
+{
+ writel(RTC_8K_ALARM2, rtc->regs_soc + RTC_8K_ISR);
+}
+
+static void armada8k_unmask_interrupt(struct armada38x_rtc *rtc)
+{
+ writel(RTC_8K_ALARM2, rtc->regs_soc + RTC_8K_IMR);
+}
+
static int armada38x_rtc_read_time(struct device *dev, struct rtc_time *tm)
{
struct armada38x_rtc *rtc = dev_get_drvdata(dev);
@@ -312,12 +365,24 @@ static const struct armada38x_rtc_data armada38x_data = {
.alarm = ALARM1,
};
+static const struct armada38x_rtc_data armada8k_data = {
+ .update_mbus_timing = rtc_update_8k_mbus_timing_params,
+ .read_rtc_reg = read_rtc_register,
+ .clear_isr = armada8k_clear_isr,
+ .unmask_interrupt = armada8k_unmask_interrupt,
+ .alarm = ALARM2,
+};
+
#ifdef CONFIG_OF
static const struct of_device_id armada38x_rtc_of_match_table[] = {
{
.compatible = "marvell,armada-380-rtc",
.data = &armada38x_data,
},
+ {
+ .compatible = "marvell,armada-8k-rtc",
+ .data = &armada8k_data,
+ },
{}
};
MODULE_DEVICE_TABLE(of, armada38x_rtc_of_match_table);
The Armada 7K/8K use the same RTC IP than the Armada 38x. However the SOC integration differs in 2 points: - MBUS bridge timing initialization - IRQ configuration at SoC level Moreover the Armada 7K/8K have an issue preventing to get the interrupt from alarm 1. This commit allows to use alarm 2 for these A7K/8K but to still use alarm 1 for the Armada 38x. Signed-off-by: Gregory CLEMENT <gregory.clement@free-electrons.com> --- .../devicetree/bindings/rtc/armada-380-rtc.txt | 8 ++- drivers/rtc/rtc-armada38x.c | 65 ++++++++++++++++++++++ 2 files changed, 70 insertions(+), 3 deletions(-)