new file mode 100644
@@ -0,0 +1,35 @@
+Amlogic meson GPIO interrupt controller
+
+Meson SoCs contains an interrupt controller which is able watch the SoC pads
+and generate an interrupt on edges or level. The controller is essentially a
+256 pads to 8 GIC interrupt multiplexer, with a filter block to select edge
+or level and polarity. We don’t expose all 256 mux inputs because the
+documentation shows that upper part is not mapped to any pad. The actual number
+of interrupt exposed depends on the SoC.
+
+Required properties:
+
+- compatible : must have "amlogic,meson8-gpio-intc” and either
+ “amlogic,meson8b-gpio-intc” for meson8b SoCs (S805) or
+ “amlogic,meson-gxbb-gpio-intc” for GXBB SoCs (S905) or
+ “amlogic,meson-gxl-gpio-intc” for GXL SoCs (S905X, S912)
+- interrupt-parent : a phandle to the GIC the interrupts are routed to.
+ Usually this is provided at the root level of the device tree as it is
+ common to most of the SoC.
+- reg : Specifies base physical address and size of the registers.
+- interrupt-controller : Identifies the node as an interrupt controller.
+- #interrupt-cells : Specifies the number of cells needed to encode an
+ interrupt source. The value must be 2.
+- meson,upstream-interrupts: Array with the 8 upstream hwirq numbers. These
+ are the hwirqs used on the parent interrupt controller.
+
+Example:
+
+gpio_interrupt: interrupt-controller@9880 {
+ compatible = "amlogic,meson-gxbb-gpio-intc",
+ "amlogic,meson-gpio-intc";
+ reg = <0x0 0x9880 0x0 0x10>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ meson,upstream-interrupts = <64 65 66 67 68 69 70 71>;
+};
This commit adds the device tree bindings description for Amlogic's GPIO interrupt controller available on the meson8b, gxbb and gxl SoC families Signed-off-by: Jerome Brunet <jbrunet@baylibre.com> --- .../amlogic,meson-gpio-intc.txt | 35 ++++++++++++++++++++++ 1 file changed, 35 insertions(+) create mode 100644 Documentation/devicetree/bindings/interrupt-controller/amlogic,meson-gpio-intc.txt