@@ -78,6 +78,7 @@ struct cqspi_st {
bool is_decoded_cs;
u32 fifo_depth;
u32 fifo_width;
+ bool rclk_en;
u32 trigger_address;
u32 wr_delay;
struct cqspi_flash_pdata f_pdata[CQSPI_MAX_CHIPSELECT];
@@ -788,7 +789,7 @@ static void cqspi_config_baudrate_div(struct cqspi_st *cqspi)
}
static void cqspi_readdata_capture(struct cqspi_st *cqspi,
- const unsigned int bypass,
+ const bool bypass,
const unsigned int delay)
{
void __iomem *reg_base = cqspi->iobase;
@@ -852,7 +853,8 @@ static void cqspi_configure(struct spi_nor *nor)
cqspi->sclk = sclk;
cqspi_config_baudrate_div(cqspi);
cqspi_delay(nor);
- cqspi_readdata_capture(cqspi, 1, f_pdata->read_delay);
+ cqspi_readdata_capture(cqspi, !cqspi->rclk_en,
+ f_pdata->read_delay);
}
if (switch_cs || switch_ck)
@@ -1049,6 +1051,8 @@ static int cqspi_of_get_pdata(struct platform_device *pdev)
return -ENXIO;
}
+ cqspi->rclk_en = of_property_read_bool(np, "cdns,rclk-en");
+
return 0;
}
Cadence QSPI IP has a adapted loop-back circuit which can be enabled by setting BYPASS field to 0 in READCAPTURE register. It enables use of QSPI return clock to latch the data rather than the internal QSPI reference clock. For high speed operations, adapted loop-back circuit using QSPI return clock helps to increase data valid window. Based on DT parameter cdns,rclk-en enable adapted loop-back circuit for boards which do have QSPI return clock provided. This patch also modifies cqspi_readdata_capture() function's bypass parameter to bool to match how its used in the function. Signed-off-by: Vignesh R <vigneshr@ti.com> --- drivers/mtd/spi-nor/cadence-quadspi.c | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-)