| Message ID | 20171018130628.11298-3-icenowy@aosc.io (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
diff --git a/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts b/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts index 7b52608cebe6..035599d870b9 100644 --- a/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts +++ b/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts @@ -78,6 +78,15 @@ }; }; + reg_vcc5v0: vcc5v0 { + compatible = "regulator-fixed"; + regulator-name = "vcc5v0"; + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + gpio = <&pio 7 23 GPIO_ACTIVE_HIGH>; /* PH23 */ + enable-active-high; + }; + wifi_pwrseq: wifi_pwrseq { compatible = "mmc-pwrseq-simple"; reset-gpios = <&pio 6 10 GPIO_ACTIVE_LOW>; /* PG10 WIFI_EN */
On newer revisions of the Banana Pi M2 Ultra boards, the 5V power output (used by HDMI, SATA and USB) is controller via a GPIO. Add the regulator node for it. Older revisions just have the 5V power output always on, and the GPIO is reserved on these boards. So it won't affect the older revisions. Signed-off-by: Icenowy Zheng <icenowy@aosc.io> --- arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts | 9 +++++++++ 1 file changed, 9 insertions(+)