@@ -109,6 +109,8 @@
wifi_pwrseq: wifi_pwrseq {
compatible = "mmc-pwrseq-simple";
reset-gpios = <&r_pio 0 8 GPIO_ACTIVE_LOW>; /* PL8 */
+ clocks = <&rtc 1>;
+ clock-names = "ext_clock";
};
};
@@ -170,6 +172,14 @@
bus-width = <4>;
non-removable;
status = "okay";
+
+ brcmf: wifi@1 {
+ reg = <1>;
+ compatible = "brcm,bcm4329-fmac";
+ interrupt-parent = <&r_pio>;
+ interrupts = <0 7 IRQ_TYPE_LEVEL_LOW>; /* PL7 */
+ interrupt-names = "host-wake";
+ };
};
&ohci0 {
@@ -342,7 +352,20 @@
&uart1 {
pinctrl-names = "default";
pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
+ uart-has-rtscts;
status = "okay";
+
+ bluetooth {
+ compatible = "brcm,bcm43438-bt";
+ max-speed = <1500000>;
+ clocks = <&rtc 1>;
+ clock-names = "lpo";
+ vbat-supply = <®_dldo2>;
+ vddio-supply = <®_dldo4>;
+ device-wakeup-gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */
+ host-wakeup-gpios = <&r_pio 0 5 GPIO_ACTIVE_HIGH>; /* PL5 */
+ shutdown-gpios = <&r_pio 0 4 GPIO_ACTIVE_HIGH>; /* PL4 */
+ };
};
/* On Pi-2 connector, RTS/CTS optional */
The AP6212 is based on the Broadcom BCM43430 or BCM43438. The WiFi side identifies as BCM43430, while the Bluetooth side identifies as BCM43438. WiFi is connected to mmc1 and the Bluetooth side is connected to UART1 in a 4 wire configuration. Same as the WiFi side, due to being the same chip and package, DLDO2 provides overall power via VBAT, and DLDO4 provides I/O power via VDDIO. The RTC clock output provides the LPO low power clock at 32.768 kHz. This patch enables WiFi and Bluetooth on OrangePi Win boards and adds missing LPO clock on the WiFi side. PCM connection also exists for Bluetooth audio, but it's not used here. Bluetooth UART speed is set to 1.5 MBaud in order to be able transmit audio. While module supports even higher speeds, currently sunxi UART driver doesn't support higher speed. Signed-off-by: Jernej Skrabec <jernej.skrabec@siol.net> --- .../dts/allwinner/sun50i-a64-orangepi-win.dts | 23 +++++++++++++++++++ 1 file changed, 23 insertions(+)