@@ -418,7 +418,7 @@
};
gmac0: ethernet@ff800000 {
- compatible = "altr,socfpga-stmmac", "snps,dwmac-3.72a", "snps,dwmac";
+ compatible = "altr,socfpga-stmmac-a10-s10", "snps,dwmac-3.72a", "snps,dwmac";
altr,sysmgr-syscon = <&sysmgr 0x44 0>;
reg = <0xff800000 0x2000>;
interrupts = <0 92 IRQ_TYPE_LEVEL_HIGH>;
@@ -438,8 +438,8 @@
};
gmac1: ethernet@ff802000 {
- compatible = "altr,socfpga-stmmac", "snps,dwmac-3.72a", "snps,dwmac";
- altr,sysmgr-syscon = <&sysmgr 0x48 0>;
+ compatible = "altr,socfpga-stmmac-a10-s10", "snps,dwmac-3.72a", "snps,dwmac";
+ altr,sysmgr-syscon = <&sysmgr 0x48 8>;
reg = <0xff802000 0x2000>;
interrupts = <0 93 IRQ_TYPE_LEVEL_HIGH>;
interrupt-names = "macirq";
@@ -458,8 +458,8 @@
};
gmac2: ethernet@ff804000 {
- compatible = "altr,socfpga-stmmac", "snps,dwmac-3.72a", "snps,dwmac";
- altr,sysmgr-syscon = <&sysmgr 0x4C 0>;
+ compatible = "altr,socfpga-stmmac-a10-s10", "snps,dwmac-3.72a", "snps,dwmac";
+ altr,sysmgr-syscon = <&sysmgr 0x4C 16>;
reg = <0xff804000 0x2000>;
interrupts = <0 94 IRQ_TYPE_LEVEL_HIGH>;
interrupt-names = "macirq";
Because of register and bits difference for setting PHY modes, PTP reference clock, and FPGA signalling, the Arria10 SoC needs to use the "altr,socfpga-stmmac-a10-s10" binding to set the correct modes. On Arria10, each EMAC has its own register for PHY modes, and they all have the same offset, thus we can use the 2nd parameter to specify the offsets for the FPGA signal bits. Signed-off-by: Dinh Nguyen <dinguyen@kernel.org> --- arch/arm/boot/dts/socfpga_arria10.dtsi | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)