| Message ID | 20190723072336.4801-1-linus.walleij@linaro.org (mailing list archive) |
|---|---|
| State | Mainlined |
| Commit | 07523a6cb6f868dfb3202a7fd5c7db2a43194f24 |
| Headers | show |
| Series | ARM: dts: ux500: set pull-up on STUIB STMPE IRQ line | expand |
diff --git a/arch/arm/boot/dts/ste-href-stuib.dtsi b/arch/arm/boot/dts/ste-href-stuib.dtsi index e6c4301c92ea..99c65fc5f8f5 100644 --- a/arch/arm/boot/dts/ste-href-stuib.dtsi +++ b/arch/arm/boot/dts/ste-href-stuib.dtsi @@ -78,6 +78,8 @@ interrupt-controller; vcc-supply = <&db8500_vsmps2_reg>; vio-supply = <&db8500_vsmps2_reg>; + pinctrl-names = "default"; + pinctrl-0 = <&stmpe_stuib_mode>; wakeup-source; st,autosleep-timeout = <1024>; @@ -147,6 +149,15 @@ }; pinctrl { + /* Pull up this GPIO pin */ + stmpe { + stmpe_stuib_mode: stmpe_stuib { + stuib_cfg { + ste,pins = "GPIO218_AH11"; + ste,config = <&gpio_in_pu>; + }; + }; + }; prox { prox_stuib_mode: prox_stuib { stuib_cfg {
Set up the STMPE IRQ line to be in pull-up mode. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- arch/arm/boot/dts/ste-href-stuib.dtsi | 11 +++++++++++ 1 file changed, 11 insertions(+)