diff mbox series

[v3,3/4] arm64: dts: allwinner: h6: add USB3 device nodes

Message ID 20191029201741.3820913-4-megous@megous.com (mailing list archive)
State New, archived
Headers show
Series Add USB 3 support for H6 and Orange Pi 3 | expand

Commit Message

Ondřej Jirman Oct. 29, 2019, 8:17 p.m. UTC 
From: Icenowy Zheng <icenowy@aosc.io>

Allwinner H6 SoC features USB3 functionality, with a DWC3 controller and
a custom PHY.

Add device tree nodes for them.

Signed-off-by: Ondrej Jirman <megous@megous.com>
Signed-off-by: Icenowy Zheng <icenowy@aosc.io>
Reviewed-by: Chen-Yu Tsai <wens@csie.org>
---
 arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi | 32 ++++++++++++++++++++
 1 file changed, 32 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
index 5d7ab540b950..9dbe63bf5a77 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
@@ -547,6 +547,38 @@ 
 			status = "disabled";
 		};
 
+		dwc3: dwc3@5200000 {
+			compatible = "snps,dwc3";
+			reg = <0x05200000 0x10000>;
+			interrupts = <GIC_SPI 26 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&ccu CLK_BUS_XHCI>,
+				 <&ccu CLK_BUS_XHCI>,
+				 <&rtc 0>;
+			clock-names = "ref", "bus_early", "suspend";
+			resets = <&ccu RST_BUS_XHCI>;
+			/*
+			 * The datasheet of the chip doesn't declare the
+			 * peripheral function, and there's no boards known
+			 * to have a USB Type-B port routed to the port.
+			 * In addition, no one has tested the peripheral
+			 * function yet.
+			 * So set the dr_mode to "host" in the DTSI file.
+			 */
+			dr_mode = "host";
+			phys = <&usb3phy>;
+			phy-names = "usb3-phy";
+			status = "disabled";
+		};
+
+		usb3phy: phy@5210000 {
+			compatible = "allwinner,sun50i-h6-usb3-phy";
+			reg = <0x5210000 0x10000>;
+			clocks = <&ccu CLK_USB_PHY1>;
+			resets = <&ccu RST_USB_PHY1>;
+			#phy-cells = <0>;
+			status = "disabled";
+		};
+
 		ehci3: usb@5311000 {
 			compatible = "allwinner,sun50i-h6-ehci", "generic-ehci";
 			reg = <0x05311000 0x100>;