@@ -182,14 +182,12 @@
ov5640: camera@3c {
compatible = "ovti,ov5640";
- pinctrl-names = "default";
- pinctrl-0 = <&ov5640_pins>;
reg = <0x3c>;
clocks = <&clk_ext_camera>;
clock-names = "xclk";
DOVDD-supply = <&v2v8>;
- powerdown-gpios = <&stmfx_pinctrl 18 GPIO_ACTIVE_HIGH>;
- reset-gpios = <&stmfx_pinctrl 19 GPIO_ACTIVE_LOW>;
+ powerdown-gpios = <&stmfx_pinctrl 18 (GPIO_ACTIVE_HIGH | GPIO_PUSH_PULL)>;
+ reset-gpios = <&stmfx_pinctrl 19 (GPIO_ACTIVE_LOW | GPIO_PUSH_PULL)>;
rotation = <180>;
status = "okay";
@@ -225,12 +223,6 @@
drive-push-pull;
bias-pull-down;
};
-
- ov5640_pins: camera {
- pins = "agpio2", "agpio3"; /* stmfx pins 18 & 19 */
- drive-push-pull;
- output-low;
- };
};
};
};
"push-pull" configuration is now fully handled by the gpiolib and the STMFX pinctrl driver. There is no longer need to declare a pinctrl group to only configure "push-pull" setting for the line. It is done directly by the gpiolib. Fixes: a502b343ebd0 ("pinctrl: stmfx: update pinconf settings") Signed-off-by: Alexandre Torgue <alexandre.torgue@st.com> Signed-off-by: Amelie Delaunay <amelie.delaunay@st.com> --- arch/arm/boot/dts/stm32mp157c-ev1.dts | 12 ++---------- 1 file changed, 2 insertions(+), 10 deletions(-)