| Message ID | 20200306114348.5172-5-nsaenzjulienne@suse.de (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | USB: pci-quirks: Add Raspberry Pi 4 quirk | expand |
Hello! On 06.03.2020 14:43, Nicolas Saenz Julienne wrote: > On the Raspberry Pi 4, after a PCI reset, VL805's firmware may either be > loaded directly from an EEPROM or, if not present, by the SoC's > VideCore. Inform VideCore that VL805 was just reset. > > Also, as this creates a dependency between XHCI_PCI and VideoCore's > firmware interface, reflect that on the firmware interface Kconfg. > > Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@suse.de> > --- > > Changes since v3: > - Add more complete error message. > - Add braces around if statement > > Changes since v1: > - Make RASPBERRYPI_FIRMWARE dependent on this quirk to make sure it > gets compiled when needed. > > drivers/firmware/Kconfig | 1 + > drivers/usb/host/pci-quirks.c | 16 ++++++++++++++++ > 2 files changed, 17 insertions(+) [...] > diff --git a/drivers/usb/host/pci-quirks.c b/drivers/usb/host/pci-quirks.c > index beb2efa71341..452f5f12b042 100644 > --- a/drivers/usb/host/pci-quirks.c > +++ b/drivers/usb/host/pci-quirks.c > @@ -16,6 +16,9 @@ > #include <linux/export.h> > #include <linux/acpi.h> > #include <linux/dmi.h> > + > +#include <soc/bcm2835/raspberrypi-firmware.h> > + > #include "pci-quirks.h" > #include "xhci-ext-caps.h" > > @@ -1243,11 +1246,24 @@ static void quirk_usb_handoff_xhci(struct pci_dev *pdev) > > static void quirk_usb_early_handoff(struct pci_dev *pdev) > { > + int ret; > + > /* Skip Netlogic mips SoC's internal PCI USB controller. > * This device does not need/support EHCI/OHCI handoff > */ > if (pdev->vendor == 0x184e) /* vendor Netlogic */ > return; > + > + if (pdev->vendor == PCI_VENDOR_ID_VIA && pdev->device == 0x3483) { > + ret = rpi_firmware_init_vl805(pdev); > + if (ret) { > + /* Firmware might be outdated, or something failed */ > + dev_warn(&pdev->dev, "Failed to load VL805's firmware: %d\n", ret); > + dev_warn(&pdev->dev, "Will continue to attempt to work, " > + "but bad things might happen. You should fix this...\n"); Don't break up the long kernel messages (checkpatch.pl should not complain about them). [...] MBR, Sergei
On Sat, 2020-03-07 at 12:54 +0300, Sergei Shtylyov wrote: > Hello! > > On 06.03.2020 14:43, Nicolas Saenz Julienne wrote: > > > On the Raspberry Pi 4, after a PCI reset, VL805's firmware may either be > > loaded directly from an EEPROM or, if not present, by the SoC's > > VideCore. Inform VideCore that VL805 was just reset. > > > > Also, as this creates a dependency between XHCI_PCI and VideoCore's > > firmware interface, reflect that on the firmware interface Kconfg. > > > > Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@suse.de> > > --- > > > > Changes since v3: > > - Add more complete error message. > > - Add braces around if statement > > > > Changes since v1: > > - Make RASPBERRYPI_FIRMWARE dependent on this quirk to make sure it > > gets compiled when needed. > > > > drivers/firmware/Kconfig | 1 + > > drivers/usb/host/pci-quirks.c | 16 ++++++++++++++++ > > 2 files changed, 17 insertions(+) > [...] > > diff --git a/drivers/usb/host/pci-quirks.c b/drivers/usb/host/pci-quirks.c > > index beb2efa71341..452f5f12b042 100644 > > --- a/drivers/usb/host/pci-quirks.c > > +++ b/drivers/usb/host/pci-quirks.c > > @@ -16,6 +16,9 @@ > > #include <linux/export.h> > > #include <linux/acpi.h> > > #include <linux/dmi.h> > > + > > +#include <soc/bcm2835/raspberrypi-firmware.h> > > + > > #include "pci-quirks.h" > > #include "xhci-ext-caps.h" > > > > @@ -1243,11 +1246,24 @@ static void quirk_usb_handoff_xhci(struct pci_dev > > *pdev) > > > > static void quirk_usb_early_handoff(struct pci_dev *pdev) > > { > > + int ret; > > + > > /* Skip Netlogic mips SoC's internal PCI USB controller. > > * This device does not need/support EHCI/OHCI handoff > > */ > > if (pdev->vendor == 0x184e) /* vendor Netlogic */ > > return; > > + > > + if (pdev->vendor == PCI_VENDOR_ID_VIA && pdev->device == 0x3483) { > > + ret = rpi_firmware_init_vl805(pdev); > > + if (ret) { > > + /* Firmware might be outdated, or something failed */ > > + dev_warn(&pdev->dev, "Failed to load VL805's firmware: > > %d\n", ret); > > + dev_warn(&pdev->dev, "Will continue to attempt to work, > > " > > + "but bad things might happen. You should fix > > this...\n"); > > Don't break up the long kernel messages (checkpatch.pl should not > complain > about them). I generally don't, but in this specific case IMO it went way too long, as in 140 charaters long, so I figured it'd be better to split it. That said, I don't really care, so I'll happily change it for v5. Regards, Nicolas
diff --git a/drivers/firmware/Kconfig b/drivers/firmware/Kconfig index ea869addc89b..40a468d712a5 100644 --- a/drivers/firmware/Kconfig +++ b/drivers/firmware/Kconfig @@ -180,6 +180,7 @@ config ISCSI_IBFT config RASPBERRYPI_FIRMWARE tristate "Raspberry Pi Firmware Driver" depends on BCM2835_MBOX + default XHCI_PCI help This option enables support for communicating with the firmware on the Raspberry Pi. diff --git a/drivers/usb/host/pci-quirks.c b/drivers/usb/host/pci-quirks.c index beb2efa71341..452f5f12b042 100644 --- a/drivers/usb/host/pci-quirks.c +++ b/drivers/usb/host/pci-quirks.c @@ -16,6 +16,9 @@ #include <linux/export.h> #include <linux/acpi.h> #include <linux/dmi.h> + +#include <soc/bcm2835/raspberrypi-firmware.h> + #include "pci-quirks.h" #include "xhci-ext-caps.h" @@ -1243,11 +1246,24 @@ static void quirk_usb_handoff_xhci(struct pci_dev *pdev) static void quirk_usb_early_handoff(struct pci_dev *pdev) { + int ret; + /* Skip Netlogic mips SoC's internal PCI USB controller. * This device does not need/support EHCI/OHCI handoff */ if (pdev->vendor == 0x184e) /* vendor Netlogic */ return; + + if (pdev->vendor == PCI_VENDOR_ID_VIA && pdev->device == 0x3483) { + ret = rpi_firmware_init_vl805(pdev); + if (ret) { + /* Firmware might be outdated, or something failed */ + dev_warn(&pdev->dev, "Failed to load VL805's firmware: %d\n", ret); + dev_warn(&pdev->dev, "Will continue to attempt to work, " + "but bad things might happen. You should fix this...\n"); + } + } + if (pdev->class != PCI_CLASS_SERIAL_USB_UHCI && pdev->class != PCI_CLASS_SERIAL_USB_OHCI && pdev->class != PCI_CLASS_SERIAL_USB_EHCI &&
On the Raspberry Pi 4, after a PCI reset, VL805's firmware may either be loaded directly from an EEPROM or, if not present, by the SoC's VideCore. Inform VideCore that VL805 was just reset. Also, as this creates a dependency between XHCI_PCI and VideoCore's firmware interface, reflect that on the firmware interface Kconfg. Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@suse.de> --- Changes since v3: - Add more complete error message. - Add braces around if statement Changes since v1: - Make RASPBERRYPI_FIRMWARE dependent on this quirk to make sure it gets compiled when needed. drivers/firmware/Kconfig | 1 + drivers/usb/host/pci-quirks.c | 16 ++++++++++++++++ 2 files changed, 17 insertions(+)