@@ -13,6 +13,7 @@
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/usb/pd.h>
/ {
model = "HiKey960";
@@ -526,6 +527,48 @@
&i2c1 {
status = "okay";
+ rt1711h: rt1711h@4e {
+ compatible = "richtek,rt1711h";
+ reg = <0x4e>;
+ status = "ok";
+ interrupt-parent = <&gpio27>;
+ interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&usb_cfg_func>;
+
+ usb_con: connector {
+ compatible = "usb-c-connector";
+ label = "USB-C";
+ data-role = "dual";
+ power-role = "dual";
+ try-power-role = "sink";
+ source-pdos = <PDO_FIXED(5000, 500, PDO_FIXED_USB_COMM)>;
+ sink-pdos = <PDO_FIXED(5000, 500, PDO_FIXED_USB_COMM)
+ PDO_VAR(5000, 5000, 1000)>;
+ op-sink-microwatt = <10000000>;
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ port@1 {
+ reg = <1>;
+ usb_con_ss: endpoint {
+ remote-endpoint = <&dwc3_ss>;
+ };
+ };
+ };
+ };
+ port {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ rt1711h_ep: endpoint@0 {
+ reg = <0>;
+ remote-endpoint = <&dwc3_role_switch>;
+ };
+ };
+ };
+
adv7533: adv7533@39 {
status = "ok";
compatible = "adi,adv7533";
@@ -612,3 +655,32 @@
interrupts = <3 IRQ_TYPE_EDGE_RISING>;
};
};
+
+&dwc3 { /* USB */
+ dr_mode = "otg";
+ maximum-speed = "super-speed";
+ phy_type = "utmi";
+ snps,dis-del-phy-power-chg-quirk;
+ snps,lfps_filter_quirk;
+ snps,dis_u2_susphy_quirk;
+ snps,dis_u3_susphy_quirk;
+ snps,tx_de_emphasis_quirk;
+ snps,tx_de_emphasis = <1>;
+ snps,dis_enblslpm_quirk;
+ snps,gctl-reset-quirk;
+ usb-role-switch;
+ role-switch-default-mode = "host";
+ port {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ dwc3_role_switch: endpoint@0 {
+ reg = <0>;
+ remote-endpoint = <&rt1711h_ep>;
+ };
+
+ dwc3_ss: endpoint@1 {
+ reg = <1>;
+ remote-endpoint = <&usb_con_ss>;
+ };
+ };
+};
@@ -1152,6 +1152,40 @@
};
};
};
+
+ usb3_otg_bc: usb3_otg_bc@ff200000 {
+ compatible = "syscon", "simple-mfd";
+ reg = <0x0 0xff200000 0x0 0x1000>;
+
+ usb_phy: usb-phy {
+ compatible = "hisilicon,hi3660-usb-phy";
+ #phy-cells = <0>;
+ hisilicon,pericrg-syscon = <&crg_ctrl>;
+ hisilicon,pctrl-syscon = <&pctrl>;
+ hisilicon,eye-diagram-param = <0x22466e4>;
+ };
+ };
+
+ dwc3: dwc3@ff100000 {
+ compatible = "snps,dwc3";
+ reg = <0x0 0xff100000 0x0 0x100000>;
+
+ clocks = <&crg_ctrl HI3660_CLK_ABB_USB>,
+ <&crg_ctrl HI3660_ACLK_GATE_USB3OTG>;
+ clock-names = "ref", "bus_early";
+
+ assigned-clocks = <&crg_ctrl HI3660_ACLK_GATE_USB3OTG>;
+ assigned-clock-rates = <229000000>;
+
+ resets = <&crg_rst 0x90 8>,
+ <&crg_rst 0x90 7>,
+ <&crg_rst 0x90 6>,
+ <&crg_rst 0x90 5>;
+
+ interrupts = <0 159 4>, <0 161 4>;
+ phys = <&usb_phy>;
+ phy-names = "usb3-phy";
+ };
};
};
This patch adds basic core dwc3, usb phy and rt1711h nodes for usb support on Hikey960. This does not enable the mux/hub functionality on the board, so the USB-A host ports will not function, but does allow the USB-C port to function in gadget mode (unfortunately not in host, as the hub/mux functionality is needed to enable vbus output to power devices in host mode). This is based on an old patch originally by Yu Chen. Cc: Yu Chen <chenyu56@huawei.com> Cc: Chunfeng Yun <chunfeng.yun@mediatek.com> Cc: Wei Xu <xuwei5@hisilicon.com> Cc: Binghui Wang <wangbinghui@hisilicon.com> Cc: YongQin Liu <yongqin.liu@linaro.org> Cc: Rob Herring <robh+dt@kernel.org> Cc: Matthias Brugger <matthias.bgg@gmail.com> Cc: Mark Rutland <mark.rutland@arm.com> Cc: linux-arm-kernel@lists.infradead.org Cc: devicetree@vger.kernel.org Signed-off-by: John Stultz <john.stultz@linaro.org> --- .../boot/dts/hisilicon/hi3660-hikey960.dts | 72 +++++++++++++++++++ arch/arm64/boot/dts/hisilicon/hi3660.dtsi | 34 +++++++++ 2 files changed, 106 insertions(+)