@@ -9,6 +9,8 @@
/dts-v1/;
#include "fsl-ls1028a.dtsi"
#include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
/ {
model = "Kontron SMARC-sAL28";
@@ -23,6 +25,36 @@
spi1 = &dspi2;
};
+ buttons0 {
+ compatible = "gpio-keys";
+
+ power-button {
+ interrupts-extended = <&sl28cpld_intc
+ 4 IRQ_TYPE_EDGE_BOTH>;
+ linux,code = <KEY_POWER>;
+ label = "Power";
+ };
+
+ sleep-button {
+ interrupts-extended = <&sl28cpld_intc
+ 5 IRQ_TYPE_EDGE_BOTH>;
+ linux,code = <KEY_SLEEP>;
+ label = "Sleep";
+ };
+ };
+
+ buttons1 {
+ compatible = "gpio-keys-polled";
+ poll-interval = <200>;
+
+ lid-switch {
+ linux,input-type = <EV_SW>;
+ linux,code = <SW_LID>;
+ gpios = <&sl28cpld_gpio3 4 GPIO_ACTIVE_LOW>;
+ label = "Lid";
+ };
+ };
+
chosen {
stdout-path = "serial0:115200n8";
};
Now that we have support for GPIO lines of the SMARC connector, map the sleep, power and lid switch signals to the corresponding keys using the gpio-keys and gpio-keys-polled drivers. The power and sleep signals have dedicated interrupts, thus we use these ones. The lid switch is just mapped to a GPIO input and needs polling. Signed-off-by: Michael Walle <michael@walle.cc> --- Changes since v8: - none Changes since v7: - none Changes since v6: - none Changes since v5: - none Changes since v4: - none Changes since v3: - see cover letter .../freescale/fsl-ls1028a-kontron-sl28.dts | 32 +++++++++++++++++++ 1 file changed, 32 insertions(+)