@@ -92,5 +92,37 @@ static inline void mte_assign_mem_tag_range(void *addr, size_t size)
#endif /* CONFIG_ARM64_MTE */
+#ifdef CONFIG_KASAN_HW_TAGS
+void mte_check_tfsr_el1(void);
+
+static inline void mte_check_tfsr_entry(void)
+{
+ mte_check_tfsr_el1();
+}
+
+static inline void mte_check_tfsr_exit(void)
+{
+ /*
+ * The asynchronous faults are sync'ed automatically with
+ * TFSR_EL1 on kernel entry but for exit an explicit dsb()
+ * is required.
+ */
+ dsb(nsh);
+ isb();
+
+ mte_check_tfsr_el1();
+}
+#else
+static inline void mte_check_tfsr_el1(void)
+{
+}
+static inline void mte_check_tfsr_entry(void)
+{
+}
+static inline void mte_check_tfsr_exit(void)
+{
+}
+#endif /* CONFIG_KASAN_HW_TAGS */
+
#endif /* __ASSEMBLY__ */
#endif /* __ASM_MTE_H */
@@ -37,6 +37,8 @@ static void noinstr enter_from_kernel_mode(struct pt_regs *regs)
lockdep_hardirqs_off(CALLER_ADDR0);
rcu_irq_enter_check_tick();
trace_hardirqs_off_finish();
+
+ mte_check_tfsr_entry();
}
/*
@@ -47,6 +49,8 @@ static void noinstr exit_to_kernel_mode(struct pt_regs *regs)
{
lockdep_assert_irqs_disabled();
+ mte_check_tfsr_exit();
+
if (interrupts_enabled(regs)) {
if (regs->exit_rcu) {
trace_hardirqs_on_prepare();
@@ -243,6 +247,8 @@ asmlinkage void noinstr enter_from_user_mode(void)
asmlinkage void noinstr exit_to_user_mode(void)
{
+ mte_check_tfsr_exit();
+
trace_hardirqs_on_prepare();
lockdep_hardirqs_on_prepare(CALLER_ADDR0);
user_enter_irqoff();
@@ -182,6 +182,37 @@ bool mte_report_once(void)
return READ_ONCE(report_fault_once);
}
+#ifdef CONFIG_KASAN_HW_TAGS
+void mte_check_tfsr_el1(void)
+{
+ u64 tfsr_el1;
+
+ if (!system_supports_mte())
+ return;
+
+ tfsr_el1 = read_sysreg_s(SYS_TFSR_EL1);
+
+ /*
+ * The kernel should never trigger an asynchronous fault on a
+ * TTBR0 address, so we should never see TF0 set.
+ * For futexes we disable checks via PSTATE.TCO.
+ */
+ WARN_ONCE(tfsr_el1 & SYS_TFSR_EL1_TF0,
+ "Kernel async tag fault on TTBR0 address");
+
+ if (unlikely(tfsr_el1 & SYS_TFSR_EL1_TF1)) {
+ /*
+ * Note: isb() is not required after this direct write
+ * because there is no indirect read subsequent to it
+ * (per ARM DDI 0487F.c table D13-1).
+ */
+ write_sysreg_s(0, SYS_TFSR_EL1);
+
+ kasan_report_async();
+ }
+}
+#endif
+
static void update_sctlr_el1_tcf0(u64 tcf0)
{
/* ISB required for the kernel uaccess routines */
@@ -247,6 +278,19 @@ void mte_thread_switch(struct task_struct *next)
/* avoid expensive SCTLR_EL1 accesses if no change */
if (current->thread.sctlr_tcf0 != next->thread.sctlr_tcf0)
update_sctlr_el1_tcf0(next->thread.sctlr_tcf0);
+ else
+ isb();
+
+ /*
+ * Check if an async tag exception occurred at EL1.
+ *
+ * Note: On the context switch path we rely on the dsb() present
+ * in __switch_to() to guarantee that the indirect writes to TFSR_EL1
+ * are synchronized before this point.
+ * isb() above is required for the same reason.
+ *
+ */
+ mte_check_tfsr_el1();
}
void mte_suspend_exit(void)