@@ -204,11 +204,14 @@ static int mox_get_board_info(struct mox_rwtm *rwtm)
return ret;
ret = mox_get_status(MBOX_CMD_BOARD_INFO, reply->retval);
- if (ret < 0 && ret != -ENODATA) {
- return ret;
- } else if (ret == -ENODATA) {
+ if (ret == -ENODATA) {
dev_warn(rwtm->dev,
"Board does not have manufacturing information burned!\n");
+ } else if (ret == -ENOSYS) {
+ dev_notice(rwtm->dev,
+ "Firmware does not support the BOARD_INFO command\n");
+ } else if (ret < 0) {
+ return ret;
} else {
rwtm->serial_number = reply->status[1];
rwtm->serial_number <<= 32;
@@ -237,10 +240,13 @@ static int mox_get_board_info(struct mox_rwtm *rwtm)
return ret;
ret = mox_get_status(MBOX_CMD_ECDSA_PUB_KEY, reply->retval);
- if (ret < 0 && ret != -ENODATA) {
- return ret;
- } else if (ret == -ENODATA) {
+ if (ret == -ENODATA) {
dev_warn(rwtm->dev, "Board has no public key burned!\n");
+ } else if (ret == -ENOSYS) {
+ dev_notice(rwtm->dev,
+ "Firmware does not support the ECDSA_PUB_KEY command\n");
+ } else if (ret < 0) {
+ return ret;
} else {
u32 *s = reply->status;
Report a notice level message if a command is not supported by the rWTM firmware. This should not be an error, merely a notice, because the firmware can be used on non-CZ.NIC boards that do not have manufacturing information burned. Signed-off-by: Marek Behún <kabel@kernel.org> Fixes: 389711b37493 ("firmware: Add Turris Mox rWTM firmware driver") --- drivers/firmware/turris-mox-rwtm.c | 18 ++++++++++++------ 1 file changed, 12 insertions(+), 6 deletions(-)