@@ -355,7 +355,6 @@
reg = <0x20050000 0x10>;
#pwm-cells = <3>;
clocks = <&cru PCLK_PWM>;
- clock-names = "pwm";
pinctrl-names = "default";
pinctrl-0 = <&pwm0_pin>;
status = "disabled";
@@ -366,7 +365,6 @@
reg = <0x20050010 0x10>;
#pwm-cells = <3>;
clocks = <&cru PCLK_PWM>;
- clock-names = "pwm";
pinctrl-names = "default";
pinctrl-0 = <&pwm1_pin>;
status = "disabled";
@@ -377,7 +375,6 @@
reg = <0x20050020 0x10>;
#pwm-cells = <3>;
clocks = <&cru PCLK_PWM>;
- clock-names = "pwm";
pinctrl-names = "default";
pinctrl-0 = <&pwm2_pin>;
status = "disabled";
@@ -388,7 +385,6 @@
reg = <0x20050030 0x10>;
#pwm-cells = <2>;
clocks = <&cru PCLK_PWM>;
- clock-names = "pwm";
pinctrl-names = "default";
pinctrl-0 = <&pwm3_pin>;
status = "disabled";
@@ -679,7 +679,6 @@
pinctrl-names = "default";
pinctrl-0 = <&pwm0_pin>;
clocks = <&cru PCLK_RKPWM>;
- clock-names = "pwm";
status = "disabled";
};
@@ -690,7 +689,6 @@
pinctrl-names = "default";
pinctrl-0 = <&pwm1_pin>;
clocks = <&cru PCLK_RKPWM>;
- clock-names = "pwm";
status = "disabled";
};
@@ -701,7 +699,6 @@
pinctrl-names = "default";
pinctrl-0 = <&pwm2_pin>;
clocks = <&cru PCLK_RKPWM>;
- clock-names = "pwm";
status = "disabled";
};
@@ -712,7 +709,6 @@
pinctrl-names = "default";
pinctrl-0 = <&pwm3_pin>;
clocks = <&cru PCLK_RKPWM>;
- clock-names = "pwm";
status = "disabled";
};
A test with the command below gives this error: /arch/arm/boot/dts/rk3036-evb.dt.yaml: pwm@20050030: clock-names: ['pwm'] is too short Devices with only one pwm clock use it to both to derive the functional clock for the device and as the bus clock. The driver does not need "clock-names" to get a handle, so remove them all. make ARCH=arm dtbs_check DT_SCHEMA_FILES=Documentation/devicetree/bindings/pwm/pwm-rockchip.yaml Signed-off-by: Johan Jonker <jbx6244@gmail.com> --- arch/arm/boot/dts/rk3036.dtsi | 4 ---- arch/arm/boot/dts/rk3288.dtsi | 4 ---- 2 files changed, 8 deletions(-)