[4/5] arm64: dts: imx8mm-venice-gw7901: add support for USB hub subload

Commit Message

Tim Harvey July 27, 2021, 4:11 p.m. UTC

The USB hub has it's reset as GPIO4_IO17 but can be sub-loaded and
VBUS provided by a VBUS regulator with GPIO4_IO2 as the enable and
GPIO1_IO15 as the active-low over-current.

Enable pull-up for GPIO4_IO17 to keep hub out of reset and move VBUS
enable to GPIO4_IO2. Additionally enable pull-up on GPIO1_IO15 so that
if the hub is loaded it never over-currents.

This allows USB to work in both configurations without a device-tree
change.

Signed-off-by: Tim Harvey <[e-mail]>
---
 arch/arm64/boot/dts/freescale/imx8mm-venice-gw7901.dts | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

Patch

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-venice-gw7901.dts b/arch/arm64/boot/dts/freescale/imx8mm-venice-gw7901.dts
index 5a1e9df39bec..db43ee28bdb6 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-venice-gw7901.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mm-venice-gw7901.dts
@@ -216,7 +216,7 @@ 
 		pinctrl-0 = <&pinctrl_reg_usb2>;
 		compatible = "regulator-fixed";
 		regulator-name = "usb_usb2_vbus";
-		gpio = <&gpio4 17 GPIO_ACTIVE_HIGH>;
+		gpio = <&gpio4 2 GPIO_ACTIVE_HIGH>;
 		enable-active-high;
 		regulator-min-microvolt = <5000000>;
 		regulator-max-microvolt = <5000000>;
@@ -824,8 +824,9 @@ 
 
 	pinctrl_reg_usb2: regusb1grp {
 		fsl,pins = <
-			MX8MM_IOMUXC_SAI1_TXD5_GPIO4_IO17	0x41
-			MX8MM_IOMUXC_GPIO1_IO15_USB2_OTG_OC	0x41
+			MX8MM_IOMUXC_SAI1_RXD0_GPIO4_IO2	0x41
+			MX8MM_IOMUXC_SAI1_TXD5_GPIO4_IO17	0x140
+			MX8MM_IOMUXC_GPIO1_IO15_USB2_OTG_OC	0x140
 		>;
 	};