@@ -184,6 +184,20 @@
};
};
};
+
+ transceiver1: can-phy0 {
+ compatible = "ti,tcan1042";
+ #phy-cells = <0>;
+ max-bitrate = <5000000>;
+ standby-gpios = <&exp1 8 GPIO_ACTIVE_HIGH>;
+ };
+
+ transceiver2: can-phy1 {
+ compatible = "ti,tcan1042";
+ #phy-cells = <0>;
+ max-bitrate = <5000000>;
+ standby-gpios = <&exp1 9 GPIO_ACTIVE_HIGH>;
+ };
};
&main_pmx0 {
@@ -294,6 +308,20 @@
AM64X_IOPAD(0x0270, PIN_INPUT, 0) /* (D18) ECAP0_IN_APWM_OUT */
>;
};
+
+ main_mcan0_pins_default: main-mcan0-pins-default {
+ pinctrl-single,pins = <
+ AM64X_IOPAD(0x0254, PIN_INPUT, 0) /* (B17) MCAN0_RX */
+ AM64X_IOPAD(0x0250, PIN_OUTPUT, 0) /* (A17) MCAN0_TX */
+ >;
+ };
+
+ main_mcan1_pins_default: main-mcan1-pins-default {
+ pinctrl-single,pins = <
+ AM64X_IOPAD(0x025c, PIN_INPUT, 0) /* (D17) MCAN1_RX */
+ AM64X_IOPAD(0x0258, PIN_OUTPUT, 0) /* (C17) MCAN1_TX */
+ >;
+ };
};
&main_uart0 {
@@ -630,3 +658,15 @@
&epwm8 {
status = "disabled";
};
+
+&main_mcan0 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&main_mcan0_pins_default>;
+ phys = <&transceiver1>;
+};
+
+&main_mcan1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&main_mcan1_pins_default>;
+ phys = <&transceiver2>;
+};
@@ -517,3 +517,11 @@
&epwm8 {
status = "disabled";
};
+
+&main_mcan0 {
+ status = "disabled";
+};
+
+&main_mcan1 {
+ status = "disabled";
+};
AM642 EVM has two CAN connecters brought out from the two MCAN instances in the main domain through transceivers. Add device tree nodes for transceivers and set the required properties in the mcan device tree nodes, in EVM device tree file. On AM642 SK there are no connectors brought out for CAN. Therefore, disable the mcan device tree nodes in the SK device tree file. Signed-off-by: Aswath Govindraju <a-govindraju@ti.com> --- arch/arm64/boot/dts/ti/k3-am642-evm.dts | 40 +++++++++++++++++++++++++ arch/arm64/boot/dts/ti/k3-am642-sk.dts | 8 +++++ 2 files changed, 48 insertions(+)