diff mbox series

[v3,3/3] ARM: dts: at91: sam9g20ek: enable udc vbus gpio pinctrl

Message ID 20221109124638.147270-4-m.grzeschik@pengutronix.de (mailing list archive)
State New, archived
Headers show
Series ARM: at91: USB Device Port fixes | expand

Commit Message

Michael Grzeschik Nov. 9, 2022, 12:46 p.m. UTC 
We set the PIOC to GPIO mode. This way the pin becomes an
input signal will be usable by the controller. Without
this change the udc on the 9g20ek does not work.

Cc: nicolas.ferre@microchip.com
Cc: ludovic.desroches@microchip.com
Cc: alexandre.belloni@bootlin.com
Cc: linux-arm-kernel@lists.infradead.org
Cc: kernel@pengutronix.de
Fixes: 5cb4e73575e3 ("ARM: at91: add at91sam9g20ek boards dt support")
Signed-off-by: Michael Grzeschik <m.grzeschik@pengutronix.de>

---
v1 -> v2: - aligned pinctrl-0 entry to one line
          - added fixes tag
v2 -> v3: - updated the fixes tag

 arch/arm/boot/dts/at91sam9g20ek_common.dtsi | 9 +++++++++
 1 file changed, 9 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/at91sam9g20ek_common.dtsi b/arch/arm/boot/dts/at91sam9g20ek_common.dtsi
index 60d61291f34445..024af2db638ebe 100644
--- a/arch/arm/boot/dts/at91sam9g20ek_common.dtsi
+++ b/arch/arm/boot/dts/at91sam9g20ek_common.dtsi
@@ -39,6 +39,13 @@  pinctrl_pck0_as_mck: pck0_as_mck {
 
 				};
 
+				usb1 {
+					pinctrl_usb1_vbus_gpio: usb1_vbus_gpio {
+						atmel,pins =
+							<AT91_PIOC 5 AT91_PERIPH_GPIO AT91_PINCTRL_DEGLITCH>;	/* PC5 GPIO */
+					};
+				};
+
 				mmc0_slot1 {
 					pinctrl_board_mmc0_slot1: mmc0_slot1-board {
 						atmel,pins =
@@ -84,6 +91,8 @@  macb0: ethernet@fffc4000 {
 			};
 
 			usb1: gadget@fffa4000 {
+				pinctrl-0 = <&pinctrl_usb1_vbus_gpio>;
+				pinctrl-names = "default";
 				atmel,vbus-gpio = <&pioC 5 GPIO_ACTIVE_HIGH>;
 				status = "okay";
 			};