@@ -889,14 +889,15 @@
{
struct imx_port *sport = dev_id;
struct tty_port *port = &sport->port.state->port;
+ typeof(sport->port.membase) membase = sport->port.membase;
u32 usr2, rx;
/* If we received something, check for 0xff flood */
- usr2 = imx_uart_readl(sport, USR2);
+ usr2 = readl(membase + USR2);
if (usr2 & USR2_RDR)
imx_uart_check_flood(sport, usr2);
- while ((rx = imx_uart_readl(sport, URXD0)) & URXD_CHARRDY) {
+ while ((rx = readl(membase + URXD0)) & URXD_CHARRDY) {
unsigned int flg = TTY_NORMAL;
sport->port.icount.rx++;
@@ -928,9 +929,8 @@
flg = TTY_OVERRUN;
sport->port.sysrq = 0;
- } else if (uart_handle_sysrq_char(&sport->port, (unsigned char)rx)) {
+ } else if (uart_handle_sysrq_char(&sport->port, (unsigned char)rx))
continue;
- }
if (sport->port.ignore_status_mask & URXD_DUMMY_READ)
continue;
These series contain a work-around for hardware RX flood in first 2 commits, and then further cleanups and optimizations of the receive IRQ handler. WARNING: the flood fix is extensively tested with older version of the kernel with DMA turned off. The DMA path is tested only a bit, as DMA has receive problems on my kernel version. Changes in v1: * Missing braces fixed. * Withdrawn patch optimizing imx_uart_readl() -> readl(), on request of Uwe Kleine-König. Sergey Organov (7): serial: imx: factor-out common code to imx_uart_soft_reset() serial: imx: work-around for hardware RX flood serial: imx: do not sysrq broken chars serial: imx: do not break from FIFO reading loop prematurely serial: imx: remove redundant USR2 read from FIFO reading loop serial: imx: stop using USR2 in FIFO reading loop serial: imx: refine local variables in rxint() drivers/tty/serial/imx.c | 225 ++++++++++++++++++++++++--------------- 1 file changed, 140 insertions(+), 85 deletions(-) Interdiff against v0: +- 2.30.1