Message ID | 20230505141407.15134-4-vaishnav.a@ti.com (mailing list archive) |
---|---|
State | New, archived |
Headers | show |
Series | arm64: dts: ti: j721e: Add HyperFlash support | expand |
diff --git a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts index 63633e4f6c59..f5cbb4b7a9fb 100644 --- a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts +++ b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts @@ -98,6 +98,12 @@ >; }; + wkup_gpio_pins_default: wkup-gpio-pins-default { + pinctrl-single,pins = < + J721E_WKUP_IOPAD(0x70, PIN_INPUT, 7) /* (C14) WKUP_GPIO0_6 */ + >; + }; + mcu_mdio_pins_default: mcu-mdio1-pins-default { pinctrl-single,pins = < J721E_WKUP_IOPAD(0x0034, PIN_OUTPUT, 0) /* (L1) MCU_MDIO0_MDC */ @@ -187,6 +193,11 @@ status = "disabled"; }; +&wkup_gpio0 { + pinctrl-names = "default"; + pinctrl-0 = <&wkup_gpio_pins_default>; +}; + &wkup_gpio1 { status = "disabled"; };
J7200 common processor board has an onboard mux for selecting whether the OSPI signals are externally routed to OSPI flash or Hyperflash. The mux state signal input is tied to WKUP_GPIO0_6 and is used by bootloader for enabling the corresponding node accordingly. Add pinmux for the same. Signed-off-by: Vaishnav Achath <vaishnav.a@ti.com> --- arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts | 11 +++++++++++ 1 file changed, 11 insertions(+)