| Message ID | 20230505141407.15134-5-vaishnav.a@ti.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | arm64: dts: ti: j721e: Add HyperFlash support | expand |
diff --git a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts index 7db0603125aa..b7a2f23b2c67 100644 --- a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts +++ b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts @@ -363,6 +363,12 @@ J721E_WKUP_IOPAD(0xb8, PIN_INPUT, 7) /* (F28) WKUP_GPIO0_2 */ >; }; + + wkup_gpio_pins_default: wkup-gpio-pins-default { + pinctrl-single,pins = < + J721E_WKUP_IOPAD(0xd0, PIN_INPUT, 7) /* (C14) WKUP_GPIO0_8 */ + >; + }; }; &wkup_uart0 { @@ -420,6 +426,11 @@ status = "disabled"; }; +&wkup_gpio0 { + pinctrl-names = "default"; + pinctrl-0 = <&wkup_gpio_pins_default>; +}; + &wkup_gpio1 { status = "disabled"; };
J721E common processor board has an onboard mux for selecting whether the OSPI signals are externally routed to OSPI flash or Hyperflash. The mux state signal input is tied to WKUP_GPIO0_6 and is used by bootloader for enabling the corresponding node accordingly. Add pinmux for the same. Signed-off-by: Vaishnav Achath <vaishnav.a@ti.com> --- arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts | 11 +++++++++++ 1 file changed, 11 insertions(+)