@@ -93,28 +93,39 @@ vin: vin {
&adc {
pinctrl-names = "default";
- pinctrl-0 = <&adc12_ain_pins_a>, <&adc12_usb_cc_pins_a>;
+ pinctrl-0 = <&adc12_usb_cc_pins_a>;
vdd-supply = <&vdd>;
vdda-supply = <&vdd>;
vref-supply = <&vrefbuf>;
- status = "disabled";
+ status = "okay";
adc1: adc@0 {
+ status = "okay";
/*
* Type-C USB_PWR_CC1 & USB_PWR_CC2 on in18 & in19.
* Use at least 5 * RC time, e.g. 5 * (Rp + Rd) * C:
* 5 * (56 + 47kOhms) * 5pF => 2.5us.
* Use arbitrary margin here (e.g. 5us).
*/
- st,min-sample-time-nsecs = <5000>;
- /* AIN connector, USB Type-C CC1 & CC2 */
- st,adc-channels = <0 1 6 13 18 19>;
- status = "okay";
+ channel@18 {
+ reg = <18>;
+ st,min-sample-time-ns = <5000>;
+ };
+ channel@19 {
+ reg = <19>;
+ st,min-sample-time-ns = <5000>;
+ };
};
adc2: adc@100 {
- /* AIN connector, USB Type-C CC1 & CC2 */
- st,adc-channels = <0 1 2 6 18 19>;
- st,min-sample-time-nsecs = <5000>;
status = "okay";
+ /* USB Type-C CC1 & CC2 */
+ channel@18 {
+ reg = <18>;
+ st,min-sample-time-ns = <5000>;
+ };
+ channel@19 {
+ reg = <19>;
+ st,min-sample-time-ns = <5000>;
+ };
};
};
U-Boot enables ADC1&2 to support USB power measurement and ADC calibration on STM32MP15x Disco boards. When leaving U-boot the ADCs do not return to power down state to keep ADC linear calibration available for kernel. Enable ADC1&2 by default on STM32MP15xx-DKx boards to align kernel DT with Uboot. This avoids to shutdown the ADCs VDDA, while the ADCs are not in power down. Use STM32 ADC generic bindings instead of legacy bindings on STM32MP15xx-DKx boards. The ADC pins on Arduino connector are not set by default. These pins are added in A7 Disco example DTs only. Signed-off-by: Olivier Moysan <olivier.moysan@foss.st.com> --- arch/arm/boot/dts/stm32mp15xx-dkx.dtsi | 29 ++++++++++++++++++-------- 1 file changed, 20 insertions(+), 9 deletions(-)