| Message ID | 20231109191355.27738-4-james.quinlan@broadcom.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | PCI: brcmstb: Configure appropriate HW CLKREQ# mode | expand |
On Thu, Nov 09, 2023 at 02:13:54PM -0500, Jim Quinlan wrote: > During long periods of the PCIe RC HW being in an L1SS sleep state, there > may be a timeout on an internal bus access, even though there may not be > any PCIe access involved. Such a timeout will cause a subsequent CPU > abort. > > Signed-off-by: Jim Quinlan <james.quinlan@broadcom.com> > --- > drivers/pci/controller/pcie-brcmstb.c | 16 ++++++++++++++++ > 1 file changed, 16 insertions(+) > > diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c > index f45c5d0168d3..f82a3e1a843a 100644 > --- a/drivers/pci/controller/pcie-brcmstb.c > +++ b/drivers/pci/controller/pcie-brcmstb.c > @@ -1031,6 +1031,21 @@ static int brcm_pcie_setup(struct brcm_pcie *pcie) > return 0; > } > > +/* > + * This extends the timeout period for an access to an internal bus. This > + * access timeout may occur during L1SS sleep periods, even without the > + * presence of a PCIe access. > + */ > +static void brcm_extend_rbus_timeout(struct brcm_pcie *pcie) > +{ > + /* TIMEOUT register is two registers before RGR1_SW_INIT_1 */ > + const unsigned int REG_OFFSET = PCIE_RGR1_SW_INIT_1(pcie) - 8; > + u32 timeout_us = 4000000; /* 4 seconds, our setting for L1SS */ > + > + /* Each unit in timeout register is 1/216,000,000 seconds */ > + writel(216 * timeout_us, pcie->base + REG_OFFSET); > +} > + > static void brcm_config_clkreq(struct brcm_pcie *pcie) > { > static const char err_msg[] = "invalid 'brcm,clkreq-mode' DT string\n"; > @@ -1067,6 +1082,7 @@ static void brcm_config_clkreq(struct brcm_pcie *pcie) > * atypical and should happen only with older devices. > */ > clkreq_cntl |= PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK; > + brcm_extend_rbus_timeout(pcie); It looks like this should be squashed into the previous patch, which added brcm_config_clkreq(). Otherwise there's a bisection hole where somebody testing at the previous patch could see the CPU abort. > } else { > /* > * "safe" -- No power savings; refclk is driven by RC
diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c index f45c5d0168d3..f82a3e1a843a 100644 --- a/drivers/pci/controller/pcie-brcmstb.c +++ b/drivers/pci/controller/pcie-brcmstb.c @@ -1031,6 +1031,21 @@ static int brcm_pcie_setup(struct brcm_pcie *pcie) return 0; } +/* + * This extends the timeout period for an access to an internal bus. This + * access timeout may occur during L1SS sleep periods, even without the + * presence of a PCIe access. + */ +static void brcm_extend_rbus_timeout(struct brcm_pcie *pcie) +{ + /* TIMEOUT register is two registers before RGR1_SW_INIT_1 */ + const unsigned int REG_OFFSET = PCIE_RGR1_SW_INIT_1(pcie) - 8; + u32 timeout_us = 4000000; /* 4 seconds, our setting for L1SS */ + + /* Each unit in timeout register is 1/216,000,000 seconds */ + writel(216 * timeout_us, pcie->base + REG_OFFSET); +} + static void brcm_config_clkreq(struct brcm_pcie *pcie) { static const char err_msg[] = "invalid 'brcm,clkreq-mode' DT string\n"; @@ -1067,6 +1082,7 @@ static void brcm_config_clkreq(struct brcm_pcie *pcie) * atypical and should happen only with older devices. */ clkreq_cntl |= PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK; + brcm_extend_rbus_timeout(pcie); } else { /* * "safe" -- No power savings; refclk is driven by RC
During long periods of the PCIe RC HW being in an L1SS sleep state, there may be a timeout on an internal bus access, even though there may not be any PCIe access involved. Such a timeout will cause a subsequent CPU abort. Signed-off-by: Jim Quinlan <james.quinlan@broadcom.com> --- drivers/pci/controller/pcie-brcmstb.c | 16 ++++++++++++++++ 1 file changed, 16 insertions(+)