@@ -127,9 +127,16 @@ static struct wm8996_retune_mobile_config wm8996_retune[] = {
},
};
+static struct gpiod_lookup_table wm8996_gpiod_table = {
+ .dev_id = "1-001a", /* Device 001a on I2C bus 1 */
+ .table = {
+ GPIO_LOOKUP("GPION", 7,
+ "wlf,ldo1ena", GPIO_ACTIVE_HIGH),
+ { },
+ },
+};
+
static struct wm8996_pdata wm8996_pdata __initdata = {
- .ldo_ena = S3C64XX_GPN(7),
- .gpio_base = CODEC_GPIO_BASE,
.micdet_def = 1,
.inl_mode = WM8996_DIFFERRENTIAL_1,
.inr_mode = WM8996_DIFFERRENTIAL_1,
@@ -370,7 +377,8 @@ static const struct {
.spi_devs = balblair_devs,
.num_spi_devs = ARRAY_SIZE(balblair_devs) },
{ .id = 0x39, .rev = 0xff, .name = "1254-EV1 Dallas Dhu",
- .i2c_devs = wm1254_devs, .num_i2c_devs = ARRAY_SIZE(wm1254_devs) },
+ .i2c_devs = wm1254_devs, .num_i2c_devs = ARRAY_SIZE(wm1254_devs),
+ .gpiod_table = &wm8996_gpiod_table },
{ .id = 0x3a, .rev = 0xff, .name = "1259-EV1 Tobermory",
.i2c_devs = wm1259_devs, .num_i2c_devs = ARRAY_SIZE(wm1259_devs) },
{ .id = 0x3b, .rev = 0xff, .name = "1255-EV1 Kilchoman",
@@ -33,8 +33,6 @@ struct wm8996_retune_mobile_config {
struct wm8996_pdata {
int irq_flags; /** Set IRQ trigger flags; default active low */
- int ldo_ena; /** GPIO for LDO1; -1 for none */
-
int micdet_def; /** Default MICDET_SRC/HP1FB_SRC/MICD_BIAS */
enum wm8996_inmode inl_mode;
@@ -42,7 +40,6 @@ struct wm8996_pdata {
u32 spkmute_seq; /** Value for register 0x802 */
- int gpio_base;
u32 gpio_default[5];
int num_retune_mobile_cfgs;
@@ -14,7 +14,7 @@
#include <linux/pm.h>
#include <linux/gcd.h>
#include <linux/gpio/driver.h>
-#include <linux/gpio.h>
+#include <linux/gpio/consumer.h>
#include <linux/i2c.h>
#include <linux/regmap.h>
#include <linux/regulator/consumer.h>
@@ -51,7 +51,7 @@ struct wm8996_priv {
struct regmap *regmap;
struct snd_soc_component *component;
- int ldo1ena;
+ struct gpio_desc *ldo_ena;
int sysclk;
int sysclk_src;
@@ -1596,9 +1596,9 @@ static int wm8996_set_bias_level(struct snd_soc_component *component,
return ret;
}
- if (wm8996->pdata.ldo_ena >= 0) {
- gpio_set_value_cansleep(wm8996->pdata.ldo_ena,
- 1);
+ if (wm8996->ldo_ena) {
+ gpiod_set_value_cansleep(wm8996->ldo_ena,
+ 1);
msleep(5);
}
@@ -1615,8 +1615,8 @@ static int wm8996_set_bias_level(struct snd_soc_component *component,
case SND_SOC_BIAS_OFF:
regcache_cache_only(wm8996->regmap, true);
- if (wm8996->pdata.ldo_ena >= 0) {
- gpio_set_value_cansleep(wm8996->pdata.ldo_ena, 0);
+ if (wm8996->ldo_ena) {
+ gpiod_set_value_cansleep(wm8996->ldo_ena, 0);
regcache_cache_only(wm8996->regmap, true);
}
regulator_bulk_disable(ARRAY_SIZE(wm8996->supplies),
@@ -2188,6 +2188,8 @@ static const struct gpio_chip wm8996_template_chip = {
.direction_input = wm8996_gpio_direction_in,
.get = wm8996_gpio_get,
.can_sleep = 1,
+ .ngpio = 5,
+ .base = -1,
};
static void wm8996_init_gpio(struct wm8996_priv *wm8996)
@@ -2195,14 +2197,8 @@ static void wm8996_init_gpio(struct wm8996_priv *wm8996)
int ret;
wm8996->gpio_chip = wm8996_template_chip;
- wm8996->gpio_chip.ngpio = 5;
wm8996->gpio_chip.parent = wm8996->dev;
- if (wm8996->pdata.gpio_base)
- wm8996->gpio_chip.base = wm8996->pdata.gpio_base;
- else
- wm8996->gpio_chip.base = -1;
-
ret = gpiochip_add_data(&wm8996->gpio_chip, wm8996);
if (ret != 0)
dev_err(wm8996->dev, "Failed to add GPIOs: %d\n", ret);
@@ -2771,15 +2767,15 @@ static int wm8996_i2c_probe(struct i2c_client *i2c)
memcpy(&wm8996->pdata, dev_get_platdata(&i2c->dev),
sizeof(wm8996->pdata));
- if (wm8996->pdata.ldo_ena > 0) {
- ret = gpio_request_one(wm8996->pdata.ldo_ena,
- GPIOF_OUT_INIT_LOW, "WM8996 ENA");
- if (ret < 0) {
- dev_err(&i2c->dev, "Failed to request GPIO %d: %d\n",
- wm8996->pdata.ldo_ena, ret);
- goto err;
- }
+ wm8996->ldo_ena = devm_gpiod_get_optional(&i2c->dev, "wlf,ldo1ena",
+ GPIOD_OUT_LOW);
+ if (IS_ERR(wm8996->ldo_ena)) {
+ ret = PTR_ERR(wm8996->ldo_ena);
+ dev_err(&i2c->dev, "Failed to request LDO ENA GPIO: %d\n",
+ ret);
+ goto err;
}
+ gpiod_set_consumer_name(wm8996->ldo_ena, "WM8996 ENA");
for (i = 0; i < ARRAY_SIZE(wm8996->supplies); i++)
wm8996->supplies[i].supply = wm8996_supply_names[i];
@@ -2814,8 +2810,8 @@ static int wm8996_i2c_probe(struct i2c_client *i2c)
goto err_gpio;
}
- if (wm8996->pdata.ldo_ena > 0) {
- gpio_set_value_cansleep(wm8996->pdata.ldo_ena, 1);
+ if (wm8996->ldo_ena) {
+ gpiod_set_value_cansleep(wm8996->ldo_ena, 1);
msleep(5);
}
@@ -2847,8 +2843,8 @@ static int wm8996_i2c_probe(struct i2c_client *i2c)
dev_info(&i2c->dev, "revision %c\n",
(reg & WM8996_CHIP_REV_MASK) + 'A');
- if (wm8996->pdata.ldo_ena > 0) {
- gpio_set_value_cansleep(wm8996->pdata.ldo_ena, 0);
+ if (wm8996->ldo_ena) {
+ gpiod_set_value_cansleep(wm8996->ldo_ena, 0);
regcache_cache_only(wm8996->regmap, true);
} else {
ret = regmap_write(wm8996->regmap, WM8996_SOFTWARE_RESET,
@@ -3054,12 +3050,10 @@ static int wm8996_i2c_probe(struct i2c_client *i2c)
wm8996_free_gpio(wm8996);
err_regmap:
err_enable:
- if (wm8996->pdata.ldo_ena > 0)
- gpio_set_value_cansleep(wm8996->pdata.ldo_ena, 0);
+ if (wm8996->ldo_ena)
+ gpiod_set_value_cansleep(wm8996->ldo_ena, 0);
regulator_bulk_disable(ARRAY_SIZE(wm8996->supplies), wm8996->supplies);
err_gpio:
- if (wm8996->pdata.ldo_ena > 0)
- gpio_free(wm8996->pdata.ldo_ena);
err:
return ret;
@@ -3070,10 +3064,8 @@ static void wm8996_i2c_remove(struct i2c_client *client)
struct wm8996_priv *wm8996 = i2c_get_clientdata(client);
wm8996_free_gpio(wm8996);
- if (wm8996->pdata.ldo_ena > 0) {
- gpio_set_value_cansleep(wm8996->pdata.ldo_ena, 0);
- gpio_free(wm8996->pdata.ldo_ena);
- }
+ if (wm8996->ldo_ena)
+ gpiod_set_value_cansleep(wm8996->ldo_ena, 0);
}
static const struct i2c_device_id wm8996_i2c_id[] = {
This converts the WM8996 codec to use GPIO descriptors, an a similar way to WM5100. The driver is instantiating a GPIO chip named wm8996, and we get rid of the base address for the GPIO chip from the platform data and just use dynamic numbering. Move base and ngpio into the static gpio_chip template. Fix up the only in-tree user which is the Cragganmore 6410 module. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- arch/arm/mach-s3c/mach-crag6410-module.c | 14 ++++++-- include/sound/wm8996.h | 3 -- sound/soc/codecs/wm8996.c | 58 ++++++++++++++------------------ 3 files changed, 36 insertions(+), 39 deletions(-)