| Message ID | 20240212095905.1057298-4-b-kapoor@ti.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | arm64: dts: ti: Modify pinmux for wkup_uart0 and mcu_uart0 | expand |
diff --git a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts index 361365bb5523..6371cb1c1fe7 100644 --- a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts +++ b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts @@ -190,8 +190,6 @@ J721S2_IOPAD(0x038, PIN_OUTPUT, 0) /* (AB28) MCASP0_ACLKX.MCAN5_TX */ &wkup_pmx2 { wkup_uart0_pins_default: wkup-uart0-default-pins { pinctrl-single,pins = < - J721S2_WKUP_IOPAD(0x070, PIN_INPUT, 0) /* (E25) WKUP_GPIO0_6.WKUP_UART0_CTSn */ - J721S2_WKUP_IOPAD(0x074, PIN_OUTPUT, 0) /* (F28) WKUP_GPIO0_7.WKUP_UART0_RTSn */ J721S2_WKUP_IOPAD(0x048, PIN_INPUT, 0) /* (D28) WKUP_UART0_RXD */ J721S2_WKUP_IOPAD(0x04c, PIN_OUTPUT, 0) /* (D27) WKUP_UART0_TXD */ >;
Only Tx and Rx Signal lines for wkup_uart0 are brought out on the Common Proc Board through SoM, but CTS and RTS signal lines are not brought on the board. Thus, remove pinmux for CTS and RTS signal lines for wkup_uart0 in J721S2. Signed-off-by: Bhavya Kapoor <b-kapoor@ti.com> --- arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts | 2 -- 1 file changed, 2 deletions(-)