@@ -685,6 +685,26 @@ pins-bus {
};
};
+ usb3_port0_pins: usb3p0-default-pins {
+ pins-vbus {
+ pinmux = <PINMUX_GPIO63__FUNC_VBUSVALID>;
+ input-enable;
+ };
+ };
+
+ usb2_port0_pins: usb2p0-default-pins {
+ pins-iddig {
+ pinmux = <PINMUX_GPIO130__FUNC_IDDIG_1P>;
+ input-enable;
+ bias-pull-up;
+ };
+
+ pins-vbus {
+ pinmux = <PINMUX_GPIO131__FUNC_USB_DRVVBUS_1P>;
+ output-low;
+ };
+ };
+
wifi_vreg_pins: wifi-vreg-pins {
pins-wifi-pmu-en {
pinmux = <PINMUX_GPIO65__FUNC_GPIO65>;
@@ -709,6 +729,10 @@ &pcie1 {
status = "okay";
};
+&pciephy {
+ status = "okay";
+};
+
&pmic {
interrupts-extended = <&pio 222 IRQ_TYPE_LEVEL_HIGH>;
};
@@ -776,6 +800,18 @@ mt6315_7_vbuck1: vbuck1 {
};
};
+&u3phy0 {
+ status = "okay";
+};
+
+&u3phy1 {
+ status = "okay";
+};
+
+&u3phy2 {
+ status = "okay";
+};
+
&uart0 {
/* Exposed at 40 pin connector */
pinctrl-0 = <&uart0_pins>;
@@ -791,6 +827,8 @@ &uart1 {
};
&ssusb0 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&usb3_port0_pins>;
role-switch-default-mode = "host";
usb-role-switch;
vusb33-supply = <&mt6359_vusb_ldo_reg>;
@@ -804,6 +842,8 @@ mtu3_hs0_role_sw: endpoint {
};
&ssusb2 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&usb2_port0_pins>;
vusb33-supply = <&mt6359_vusb_ldo_reg>;
status = "okay";
};
Enable the PCIe0 PHY to be able to set calibrations read from eFuses, improving the stability and performance of the PCIe link. While at it, also enable the T-PHYs for both PCIe1 and for USB, allowing the USB ports to finally switch to gadget mode if needed, and configure the VBUS/ID pins of both USB ports for the same. Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com> --- .../dts/mediatek/mt8395-radxa-nio-12l.dts | 40 +++++++++++++++++++ 1 file changed, 40 insertions(+)