diff --git a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
index 8230d53cd69609d44b4a832cf214afdc2ee90e02..4c1e02a4e7a25c8fc6f55f06fe27d0f2b41483d7 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
@@ -193,6 +193,7 @@ J721E_IOPAD(0x1c0, PIN_OUTPUT, 1) /* (AA2) SPI0_CS0.UART0_RTSn */
 			J721E_IOPAD(0x1e8, PIN_INPUT, 0) /* (AB2) UART0_RXD */
 			J721E_IOPAD(0x1ec, PIN_OUTPUT, 0) /* (AB3) UART0_TXD */
 		>;
+		bootph-all;
 	};
 
 	main_uart1_pins_default: main-uart1-default-pins {
@@ -234,6 +235,7 @@ J721E_IOPAD(0x240, PIN_INPUT, 0) /* (R26) MMC1_DAT3 */
 			J721E_IOPAD(0x258, PIN_INPUT, 0) /* (P23) MMC1_SDCD */
 			J721E_IOPAD(0x25c, PIN_INPUT, 0) /* (R28) MMC1_SDWP */
 		>;
+		bootph-all;
 	};
 
 	vdd_sd_dv_alt_pins_default: vdd-sd-dv-alt-default-pins {
@@ -247,6 +249,7 @@ main_usbss0_pins_default: main-usbss0-default-pins {
 			J721E_IOPAD(0x290, PIN_OUTPUT, 0) /* (U6) USB0_DRVVBUS */
 			J721E_IOPAD(0x210, PIN_INPUT, 7) /* (W3) MCAN1_RX.GPIO1_3 */
 		>;
+		bootph-all;
 	};
 
 	main_usbss1_pins_default: main-usbss1-default-pins {
@@ -342,6 +345,7 @@ wkup_uart0_pins_default: wkup-uart0-default-pins {
 			J721E_WKUP_IOPAD(0xa0, PIN_INPUT, 0) /* (J29) WKUP_UART0_RXD */
 			J721E_WKUP_IOPAD(0xa4, PIN_OUTPUT, 0) /* (J28) WKUP_UART0_TXD */
 		>;
+		bootph-all;
 	};
 
 	mcu_uart0_pins_default: mcu-uart0-default-pins {
@@ -351,6 +355,7 @@ J721E_WKUP_IOPAD(0xec, PIN_OUTPUT, 0) /* (J27) WKUP_GPIO0_15.MCU_UART0_RTSn */
 			J721E_WKUP_IOPAD(0xe4, PIN_INPUT, 0) /* (H28) WKUP_GPIO0_13.MCU_UART0_RXD */
 			J721E_WKUP_IOPAD(0xe0, PIN_OUTPUT, 0) /* (G29) WKUP_GPIO0_12.MCU_UART0_TXD */
 		>;
+		bootph-all;
 	};
 
 	sw11_button_pins_default: sw11-button-default-pins {
@@ -370,6 +375,7 @@ J721E_WKUP_IOPAD(0x4c, PIN_INPUT, 0) /* (C23) MCU_OSPI1_D3 */
 			J721E_WKUP_IOPAD(0x3c, PIN_INPUT, 0) /* (B23) MCU_OSPI1_DQS */
 			J721E_WKUP_IOPAD(0x38, PIN_INPUT, 0) /* (A23) MCU_OSPI1_LBCLKO */
 		>;
+		bootph-all;
 	};
 
 	mcu_cpsw_pins_default: mcu-cpsw-default-pins {
@@ -435,12 +441,14 @@ &wkup_uart0 {
 	status = "reserved";
 	pinctrl-names = "default";
 	pinctrl-0 = <&wkup_uart0_pins_default>;
+	bootph-all;
 };
 
 &mcu_uart0 {
 	status = "okay";
 	pinctrl-names = "default";
 	pinctrl-0 = <&mcu_uart0_pins_default>;
+	bootph-all;
 };
 
 &main_uart0 {
@@ -449,6 +457,7 @@ &main_uart0 {
 	pinctrl-0 = <&main_uart0_pins_default>;
 	/* Shared with ATF on this platform */
 	power-domains = <&k3_pds 146 TI_SCI_PD_SHARED>;
+	bootph-all;
 };
 
 &main_uart1 {
@@ -487,6 +496,7 @@ &main_sdhci0 {
 	/* eMMC */
 	status = "okay";
 	non-removable;
+	bootph-all;
 	ti,driver-strength-ohm = <50>;
 	disable-wp;
 };
@@ -498,12 +508,14 @@ &main_sdhci1 {
 	vqmmc-supply = <&vdd_sd_dv_alt>;
 	pinctrl-names = "default";
 	pinctrl-0 = <&main_mmc1_pins_default>;
+	bootph-all;
 	ti,driver-strength-ohm = <50>;
 	disable-wp;
 };
 
 &usb_serdes_mux {
 	idle-states = <1>, <0>; /* USB0 to SERDES3, USB1 to SERDES1 */
+	bootph-all;
 };
 
 &serdes_ln_ctrl {
@@ -513,6 +525,7 @@ &serdes_ln_ctrl {
 		      <J721E_SERDES3_LANE0_USB3_0_SWAP>, <J721E_SERDES3_LANE1_USB3_0>,
 		      <J721E_SERDES4_LANE0_EDP_LANE0>, <J721E_SERDES4_LANE1_EDP_LANE1>,
 		      <J721E_SERDES4_LANE2_EDP_LANE2>, <J721E_SERDES4_LANE3_EDP_LANE3>;
+	bootph-all;
 };
 
 &serdes_wiz3 {
@@ -533,6 +546,7 @@ serdes3_usb_link: phy@0 {
 &usbss0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&main_usbss0_pins_default>;
+	bootph-all;
 	ti,vbus-divider;
 };
 
@@ -541,6 +555,7 @@ &usb0 {
 	maximum-speed = "super-speed";
 	phys = <&serdes3_usb_link>;
 	phy-names = "cdns3,usb3-phy";
+	bootph-all;
 };
 
 &usbss1 {
@@ -613,6 +628,7 @@ partition@800000 {
 			partition@3fe0000 {
 				label = "qspi.phypattern";
 				reg = <0x3fe0000 0x20000>;
+				bootph-all;
 			};
 		};
 	};
diff --git a/arch/arm64/boot/dts/ti/k3-j721e-som-p0.dtsi b/arch/arm64/boot/dts/ti/k3-j721e-som-p0.dtsi
index cef47c67493fcc24f56f3cbd409a0268aaa5176f..0722f6361cc8b0bfd2c666cc5a9f1b70e3070859 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-som-p0.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-j721e-som-p0.dtsi
@@ -151,6 +151,7 @@ wkup_i2c0_pins_default: wkup-i2c0-default-pins {
 			J721E_WKUP_IOPAD(0xf8, PIN_INPUT_PULLUP, 0) /* (J25) WKUP_I2C0_SCL */
 			J721E_WKUP_IOPAD(0xfc, PIN_INPUT_PULLUP, 0) /* (H24) WKUP_I2C0_SDA */
 		>;
+		bootph-all;
 	};
 
 	pmic_irq_pins_default: pmic-irq-default-pins {
@@ -173,6 +174,7 @@ J721E_WKUP_IOPAD(0x0024, PIN_INPUT, 0)  /* MCU_OSPI0_D6 */
 			J721E_WKUP_IOPAD(0x0028, PIN_INPUT, 0)  /* MCU_OSPI0_D7 */
 			J721E_WKUP_IOPAD(0x002c, PIN_OUTPUT, 0) /* MCU_OSPI0_CSn0 */
 		>;
+		bootph-all;
 	};
 
 	mcu_fss0_hpb0_pins_default: mcu-fss0-hpb0-default-pins {
@@ -192,6 +194,7 @@ J721E_WKUP_IOPAD(0x20, PIN_INPUT, 1)  /* MCU_HYPERBUS0_DQ5 */
 			J721E_WKUP_IOPAD(0x24, PIN_INPUT, 1)  /* MCU_HYPERBUS0_DQ6 */
 			J721E_WKUP_IOPAD(0x28, PIN_INPUT, 1)  /* MCU_HYPERBUS0_DQ7 */
 		>;
+		bootph-all;
 	};
 };
 
@@ -422,6 +425,7 @@ partition@800000 {
 			partition@3fe0000 {
 				label = "ospi.phypattern";
 				reg = <0x3fe0000 0x20000>;
+				bootph-all;
 			};
 		};
 	};
@@ -440,6 +444,7 @@ &hbmc {
 	flash@0,0 {
 		compatible = "cypress,hyperflash", "cfi-flash";
 		reg = <0x00 0x00 0x4000000>;
+		bootph-all;
 
 		partitions {
 			compatible = "fixed-partitions";
