@@ -860,6 +860,32 @@ static int lvts_ctrl_init(struct device *dev, struct lvts_domain *lvts_td,
return 0;
}
+static void lvts_ctrl_monitor_enable(struct device *dev, struct lvts_ctrl *lvts_ctrl, bool enable)
+{
+ /*
+ * Bitmaps to enable each sensor on filtered mode in the MONCTL0
+ * register.
+ */
+ u32 sensor_filt_bitmap[] = { BIT(0), BIT(1), BIT(2), BIT(3) };
+ u32 sensor_map = 0;
+ int i;
+
+ if (lvts_ctrl->mode != LVTS_MSR_FILTERED_MODE)
+ return;
+
+ if (enable) {
+ lvts_for_each_valid_sensor(i, lvts_ctrl)
+ sensor_map |= sensor_filt_bitmap[i];
+ }
+
+ /*
+ * Bits:
+ * 9: Single point access flow
+ * 0-3: Enable sensing point 0-3
+ */
+ writel(sensor_map | BIT(9), LVTS_MONCTL0(lvts_ctrl->base));
+}
+
/*
* At this point the configuration register is the only place in the
* driver where we write multiple values. Per hardware constraint,
@@ -1381,8 +1407,11 @@ static int lvts_suspend(struct device *dev)
lvts_td = dev_get_drvdata(dev);
- for (i = 0; i < lvts_td->num_lvts_ctrl; i++)
+ for (i = 0; i < lvts_td->num_lvts_ctrl; i++) {
+ lvts_ctrl_monitor_enable(dev, &lvts_td->lvts_ctrl[i], false);
+ usleep_range(100, 200);
lvts_ctrl_set_enable(&lvts_td->lvts_ctrl[i], false);
+ }
clk_disable_unprepare(lvts_td->clk);
@@ -1400,8 +1429,11 @@ static int lvts_resume(struct device *dev)
if (ret)
return ret;
- for (i = 0; i < lvts_td->num_lvts_ctrl; i++)
+ for (i = 0; i < lvts_td->num_lvts_ctrl; i++) {
lvts_ctrl_set_enable(&lvts_td->lvts_ctrl[i], true);
+ usleep_range(100, 200);
+ lvts_ctrl_monitor_enable(dev, &lvts_td->lvts_ctrl[i], true);
+ }
return 0;
}
When configured in filtered mode, the LVTS thermal controller will monitor the temperature from the sensors and trigger an interrupt once a thermal threshold is crossed. Currently this is true even during suspend and resume. The problem with that is that when enabling the internal clock of the LVTS controller in lvts_ctrl_set_enable() during resume, the temperature reading can glitch and appear much higher than the real one, resulting in a spurious interrupt getting generated. Disable the temperature monitoring and give some time for the signals to stabilize during suspend in order to prevent such spurious interrupts. Cc: stable@vger.kernel.org Reported-by: Hsin-Te Yuan <yuanhsinte@chromium.org> Closes: https://lore.kernel.org/all/20241108-lvts-v1-1-eee339c6ca20@chromium.org/ Fixes: 8137bb90600d ("thermal/drivers/mediatek/lvts_thermal: Add suspend and resume") Signed-off-by: Nícolas F. R. A. Prado <nfraprado@collabora.com> --- drivers/thermal/mediatek/lvts_thermal.c | 36 +++++++++++++++++++++++++++++++-- 1 file changed, 34 insertions(+), 2 deletions(-)